12Volt DirectStart CS423 Installation Manual - Installation Info
CS400 DIRECTSTART
REMOTE CAR STARTER + ALARM
CS400 VERSION 412
2
INSTALLATION INFO
System Wiring
Transmitter Programming: How to
System Programming: How to, Example,
Bank I Programming: Basic features.
Bank II Programming: Remote start features
Tach Programming: Tach Setting, Adjusting, Engine Crank Protection
Diesel Installation: Description of Options
Safety device Connections: Automatic & Manual transmission Vehicles
Parking Light Status indicators: Flash Codes, # of light flashes & description
Main Wiring Diagram: Wiring Schematic
SYSTEM CONTENTS
1-Base Control Module
1-Instructions - Owners,Install,Warranty
1-6 Pin Main Power Harness & Connector
1-14 Pin Input/Output Harness & Connector
1-3 Button Transmitter (Optional 2
nd
Transmitter)
1-3 Pin RF Powered Antenna
WARNING: This unit must be installed with all safety devices supplied!!
Transmitter Battery Replacement
1) Remove screw(s) from back of transmitter. 2) Remove front cover and remove old battery carefully.3)
Replace with new GPA23A 12 volt battery. Verify polarity (+ -). Normal battery life is approximately two years
but can vary depending on use. For best performance change battery once a year.
MANUAL TRANSMISSION VEHICL
MANUAL TRANSMISSION VEHICL
MANUAL TRANSMISSION VEHICL
MANUAL TRANSMISSION VEHICLES
ES
ES
ES:
:::
If remote starter is installed on a manual transmission vehicle, a “READY MODE” safety procedure
must be followed EACH time you exit the vehicle. The safety procedure is in place to REMIND the user
to leave the vehicle in NEUTRAL and NOT in gear before remote starting. If safety procedure is not
completed, vehicle WILL NOT remote start but all other options will function normally.
* AN ON-BOARD JUMPER MUST BE REMOVED TO ACTIVATE MANUAL TRANSMISSION PROGRAMMING AND
SAFETY FEATURES. FAILURE TO DO SO WILL RESULT IN UNSAFE OPERATION WHICH COULD RESULT IN
INJURY OR DEATH. INSTALLATION IN MANUAL TRANSMISSION VEHICLES IS AT THE SOLE DISCRETION OF
THE USER. TRILOGIX ELECTRONIC SYSTEMS INC. CANNOT VALIDATE NOR ENSURE THAT ANY OR ALL SAFETY
REQUIREMENTS ARE MET DURING INSTALLATION AND THEREFORE ACCEPTS NO RESPONSIBILTY FOR THE
INSTALLATION OF ANY REMOTE CAR STARTER IN A MANUAL TRANSMISSION VEHICLE. DO NOT INSTALL IN
CONVERTIBLES, SOFT-TOPS OR VEHICLES IN WHICH DOORS CAN BE REMOVED AND DOOR SWITCH
DISABLED.
START – BUTTON # II
UNLOCK – BUTTON # III
LOCK – BUTTON # I