12Volt DirectStart CS423 Installation Manual - Changing Function Settings
CS400 DIRECTSTART
REMOTE CAR STARTER + ALARM
CS400 VERSION 412
5
CHANGING FUNCTION SETTINGS
TO ENTER FUNCTION PROGRAMMING YOU REPEAT THE TRANSMITTER
PROGRAMMING SEQUENCE:
1. Open the hood. (J2-PIN#14 Violet hood switch wire must see (-) ground )
2. Toggle the Ignition Key ON and OFF 8 times…(Start and Finish in the OFF position)
Parklights will come on solid to indicate system is in Transmittter learning mode.
3. Press ‘LOCK ‘ Button to learn the transmitter. System will confirm transmitter is
programmed correctly by flashing the parking lights (1) one time if Tx is new to the system
or (2) twice if Tx has previously been learned (programmed)
4. After the parking lights flash to confirm Tx are programmed you must immediately select
the programming BANK you wish to enter. BANK I or BANK II
•
BANK I is selected by pressing the ‘LOCK’ button # I confirmed by (1) one park light flash
•
BANK II is selected by pressing the ‘START’ button #2 confirmed by (2) park light flashes
FUNCTIONS
FUNCTIONS
FUNCTIONS
FUNCTIONS PROGRAMMING
PROGRAMMING
PROGRAMMING
PROGRAMMING
•
IMMEDIATELY AFTER BANK SELECTION CONFIRMATION YOU ARE AUTOMATICALLY
PROMPTED TO THE FIRST FUNCTION SETTING IN THAT BANK.
•
TO CHANGE BETWEEN THE (3) THREE OPTIONS OF EACH FUNCTION YOU PRESS THE
“STAR” BUTTON (B) BETWEEN 1-3 TIMES AND THEN PRESS THE “LOCK “ BUTTON (A)
TO ‘SAVE’ THE SELECTION.
EXAMPLE : TO CHANGE THE DOORLOCK FUNCTION TO PASSIVE DOORLOCKS (BANK I -
FUNCTION #1- OPTION #2)
PRESS THE ‘STAR’ BUTTON (B) TWICE THEN PRESS THE “LOCK’ BUTTON (A) TO SAVE
SELECTION. PARK LIGHTS WILL CONFIRM WITH (2) TWO FLASHES.
•
SYSTEM AUTOMATICALLY PROMPTS YOU TO THE NEXT FUNCTION SETTING ONCE THE
LAST FUNCTION SETTING HAS BEEN CONFIRMED.
TO SKIP A FUNCTION
TO SKIP A FUNCTION
TO SKIP A FUNCTION
TO SKIP A FUNCTION
•
YOU CAN ADVANCE FORWARD TO A SPECIFIC FUNCTION WITHOUT CHANGING
PREVIOUS FUNCTIONS BY PRESSING THE “UNLOCK’ BUTTON (C).
•
EVERYTIME THE UNLOCK BUTTON IS PRESSED THE SYSTEM ADVANCES ONE
FUNCTION (PARKLIGHT WILL FLASH BETWEEN 1-3 TIMES JUST TO TELL YOU WHAT
OPTION IS SAVED IN MEMORYON THE FUNCTION YOU ARE BYPASSING.)
You may exit programming and save changes any time by turning the key to the ON position
!