2 Save Energy CM113 User Manual - Getting Started
0
gETTINg STARTED
you will need
As you unpack and begin to set up your new
OWL
TM
you will need the following equipment:
• User manual – for instructions on how to set up and use the product.
• A hammer and 2x 2mm head nails – to fix the mounting bracket/unit to the wall. Alternatively you may
screw the bracket to the wall.
• A small cross-head screw driver - to open the battery compartment of the Sender Box.
Unpacking the product
When you unpack your
OWL
TM
, make sure to keep all the packing materials in a safe place, in case you need
to later transport or return it for servicing.
In the box, you will find:
Remote Monitor
Sender Box
Sensor
Batteries x 6 AA User manual
AA alkaline
Batteries
The Portable Main Unit Receiver and the Remote Transmitter both use 3 x UM-3/AA 1.5V alkaline batteries.
Do not use other types of batteries. No other power source is necessary to run the units.
Loading the batteries:
Remote Monitor
Sender Box
Diagram
Instructions
Diagram Instructions
NOTE
Replace the batteries whenever the weak battery mark ‘main’ or ‘remote’ ( ) shows, the display is
dim, or the display does not illuminate when the power is on. Replace all the batteries at the same time – it is
unwise
to mix old and new batteries.
Remove the cover with a screwdriver.
Then follow the same instructions as
the main unit.
Once done, replace the cover and
screw back the cover onto the unit.
Install the batteries by matching
the correct polarity. Always use the
correct battery type (
3 x UM-3/AA
1.5V alkaline batteries
).
Warning:
Reversing the polarity
may damage the product.