2 Save Energy CM113 User Manual - page 14
4
Setting the cost-per-hour value
Diagram
Instructions
1. Press and hold
mode
for 2 seconds. The first digit of the electricity
cost-per-hour flashes.
2. Use the
arrow key
to change the flashing value (0-9). Press
mode
to set value. Repeat for all digits.
3. Press
mode
when finished.
Setting the greenhouse gas emission per kW rate (see greenhouse gas)
To set the unit and rate of greenhouse gas emissions per electric current production (see
greenhouse
gas
) follow the instructions below:
Diagram
Instructions
1. Press
mode
to change to the Greenhouse Gas display.
2. Press and hold
mode
for 2 seconds.
3. The Greenhouse Gas emission unit blinks. Use the
arrow key
to toggle
between units (Kg/Hour or Ton/Year). Press
mode
to confirm.
4. The Greenhouse Gas value blinks. Use the
arrow key
to change
the value.
5. Press
mode
again to return to the Greenhouse gas display.
NOTE
It may be necessary to change this setting for a product used in the UK, where average greenhouse
gas emissions are approximately 1 kilogram per kW. If a precise rate is required, or if you have purchased
a “Green Energy” product, contact your local electricity retailer.
Setting the Battery power save mode
You can save battery power by changing the receiving speed of the Remote Monitor from every 6 seconds
(MAX) to every minute. To change the setting, follow the instructions below:
Diagram
Instructions
1. When ‘MAX’ icon is displayed, press and hold the arrow key for 2
seconds.
2. The ‘MAX’ icon disappears. Repeat these steps to re-enable “MAX’
receiving speed.