2 Save Energy CM113 User Manual - page 16
16
Activating the alarm
To activate the alarm follow the instructions below:
Diagram
Instructions
1. On the back of the unit locate the grey alarm on/off button (furthest
to the right).
2. Press the alarm on/off button once to activate or deactivate the
alarm.
3. Hi icon will appear when the alarm is activated and disappear when it
is deactivated.
NOTE
The alarm will sound for 4 seconds and the display will ßash continually when the alarm is exceeded.
It will cease if the cost-per-hour falls below the limit, or you can press any button to stop the alarm. A Ò----Ò
message means the alarm is disabled.
USING THE SEARCH AND CHECK FUNCTIONS
The
TM
Remote Monitor and Sender Box include search and check functions to quickly re-establish a
connection should the transmission be broken (i.e. if the units are too far apart, or experience interference
from other devices such as a radio or television).
Using the search function
To activate the search and check function, follow the instructions below:
Diagram
Instructions
1. Locate the
search
button on the back of the Remote Monitor
(left hand grey button). Press once and hold for 2 seconds
(unit will beep twice).
2. Connection with the Sender Box will be re-established, when the
next transmission signal is received.
3. If no connection can be made, locate the
check
button on the
Sender Box. Press once.
4. Press the
search
button on the back of the Remote Monitor
again as in step 1.
NOTE
Make sure you press the Search button within 30 seconds of activating the Check function. If a
connection is not made try resetting both the Remote Monitor and the Sender Box. If you are resetting
CHECK BUTTON
ON/OFF
SEARCH
RESET
ALARM