2 Save Energy CM113 User Manual - Warnings
E
6
WARNINGS
To ensure you use your product correctly and safely, read these Warnings and the User Manual before using
the product. These warnings provide important safety information and should be observed at all times.
WARNINGS
¥
When fitting sensors if in any doubt always contact a qualified electrician.
¥ Do not attempt to repair the product yourself. Contact the retailer or our customer service department if it
requires servicing.
¥ Take precautions when handling all battery types. They can cause injuries, burns, or property as a result of
contact with conducting materials, heat, corrosive materials or explosives. Remove the batteries
before storing the product for long periods of time.
¥ Do not immerse the device in water.
¥ Do not, under any circumstances, touch the exposed electronic circuitry of the device as there is a danger
of electric shock should it become exposed.
¥ Take special care when handling a damaged LCD display, as the liquid crystals can be harmful to your health.
¥ Do not use or store the device, including the remote sensor, in locations that may adversely affect the product
such as rain, snow, desert, and magnetic Þelds.
¥ Do not use this device in aircrafts or hospitals. The use of radio frequency products can cause malfunctions in
the control devices of other equipment.
¥ Do not subject the product to impact or shock.
¥ When disposing of this product, do so in accordance with your local waste disposal regulations.
SAFETY AND CARE INSTRUCTIONS
Safety precautions
Please observe the following safety precautions when setting up and using this product.
¥ LCD panel Ð The LCD panel is made of glass, and may break if the unit is dropped or impacted.
¥ Heat sources Ð Keep the product away from heat sources such as radiators, stoves, heaters, and
other heat-generating products.
¥ Water and moisture Ð Do not use the product in or near water or in high moisture areas such as a
bathroom.
¥ Power source Ð The product may be susceptible to power surges, and the Sensor cable should be
disconnected from the Sender Box during severe storms.
Caring for this product
To ensure you receive the maximum beneÞt from using this product, please observe the following
guidelines.
¥ Cleaning Ð Disconnect the Sensor and remove the batteries from the Sender Box and the Remote
Monitor before cleaning. Use a damp cloth. Do not use liquid cleaning agents,benzene, thinner, or
aerosols.
¥ Ventilation Ð The vents and other openings are designed for ventilation and should not be blocked
or covered. Blocking the vents can cause the product to overheat and can damage the unit.
¥ Repair Ð Do not attempt to repair the product or modify the circuitry by yourself. Contact the retailer
or a qualiÞed electrical person if the product requires servicing. Only use replacement parts that are
recommended by the manufacturer.
¥ Do not scratch hard objects against the LCD display as this may cause damage.
¥ Do not leave discharged batteries in either receiver or transmitter unit for any length of time, as they
may leak and cause corrosion.
!