3D Nord magicolor 3100 Maintenance Manual

Summary of magicolor 3100

  • Page 1

    Magicolor 3100 maintenance guide ® 1800657-001b ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 2

    Dear magicolor 3100 series printer user: thank you for purchasing a magicolor 3100 series printer. Place this maintenance guide near the printer for quick information. For technical support: point your web browser to www.Minolta-qms.Com, and then click on on-line help & drivers. The answer base (the...

  • Page 3: Media Specifications

    1 media specifications all media is fed short edge first and is output to the 250-sheet output tray on top of the printer. The imageable (printable) area for all media sizes is the page size minus 0.157" (4 mm) from all edges. Media inches millimeters source* autoduplex a4 8.2 x 11.7 210.0 x 297.0 u...

  • Page 4: Loading Media

    2 loading media 1 2 3 a 5 a 5 5 4 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 5

    3 5 76 7 8 8 9 10 11 12 13 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 6: Clearing Media Jams

    4 clearing media jams 1 8 9 2 13 5 16 12 6 1 2 3 4 5 4444 5555 a 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 7

    5 7 8 9 h b 4444 5555 10 11 12 4444 5555 13 14 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 8: Maintenance Schedule

    6 maintenance schedule attention consumable life is expressed in simplex letter/a4 pages at normal 5% coverage in continuous printing. A duplex page is equivalent to two simplex pages. The stated life expectancy of each consumable is based on printing under specific operating conditions, such as rat...

  • Page 9

    7 consumables life expectancies fuser unit and media feed roller(s) approximately 100,000 simplex pages imaging unit refer to the user’s guide , go to www.Minolta-qms.Com/ support then click on answer base, or go to www.Minolta-qms.Com/products for current life expectancies. Toner percent coverage o...

  • Page 10: Error Messages

    8 error messages frequent jams in any area indicate that the area should be checked, repaired, cleaned, and/or replaced. Repeated jams will also occur if the media does not match the specifications noted in the user’s guide . Error message problem solution adc sensor dustiness warning the density se...

  • Page 11

    9 media jam x> duplex jams occur in the duplex area. Locate and remove the jam. Feed jams occur between the media tray and the print engine. A feed jam may be as simple as a sheet of media not being picked up, or it may be that the media was picked up but not fed properly. Fuser jams occur in the fu...

  • Page 12: Replacing A Toner Cartridge

    10 replacing a toner cartridge 1 2 3 4 5 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 13

    11 7 8 9 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 14: Replacing The Imaging Unit

    12 replacing the imaging unit a 1 2 3 4 5 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 15

    13 7 8 9 2 1 10 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 16: Roller(S)

    14 replacing the fuser unit and media feed roller(s) fuser unit a 1 2 3 b 4444 5555 4 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 17

    15 5 6 7 8 1 1 2 1 2 1 2 1 5555 5555 4444 9 10 11 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 18: Media Feed Roller(S)

    16 media feed roller(s) 1 2 12 6 66 6 13 14 15 16 2 1 3 17 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 19: Replacing The Transfer Unit

    17 replacing the transfer unit a 1 2 2 1 1 4444 4444 5555 5555 3 4 5 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 20: Cleaning Schedule

    18 cleaning schedule cleaning guidelines clean this item thoroughly... After... Exterior once a month or as needed, whichever comes first interior (density sensor) adc sensor dustiness warning appears in the message window. Note: we recommend that you do not clean elsewhere inside the printer. If ne...

  • Page 21: Cleaning The Density Sensor

    19 cleaning the printer exterior cleaning the density sensor a 1 5555 5555 4444 4444 2 3 4 5 2 1 6 ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 22

    Ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 23

    Ednord - istedgade 37a - 9000 aalborg - telefon 96333500

  • Page 24

    Ednord - istedgade 37a - 9000 aalborg - telefon 96333500