A.MENARINI GLUCOCARD MX Operating Manual - page 6
- 6 -
- 7 -
Alarm
to follow the black
arrows ( ).
1. Select an
alarm number.
1. Select a
setting.
1. Set the year.
2. Set the month.
3. Set the day.
1. Select a time
format.
12h or 24h
2. Set the hour.
3. Set the minute.
4. Select a date
format.
d-n: Day-month
n-d: Month-day
on1: Low
on2: Normal
on3: High
oFF: Off
1. Make sure
the meter is
off.
2.
To go to “SET”:
2. Turn on the
alarm.
3. Set the hour.
4. Set the minute.
5. Go to “End”.
1. Turn on the
expiration
warning.
The date 6 months
from the current
date appears.
1. Turn on the
ECO mode.
The ECO mode
extends battery
life.
1. Turn on the
meal amount
flag.
1. Select a
setting.
7d, 14d, 30d or
90d
You can make 4
alarm settings.
A1, A2, A3 or A4
Current setting
Current setting
Current setting
Current setting
Current setting
Current setting
Current setting
Current setting
Beeper volume
Date
Time
ECO
Setup end
Test strip
expiration
Result average
display
Meal amount
to change the settings or
numbers.
or
to scroll through the
settings or numbers:
or
to follow the gray
arrows ( ).
Hold for
5 seconds
To the top of the alarm setting.
Back to “Alarm”
Hold
To make another alarm
setting, repeat steps 1 to 4.
To the top of the
beeper volume
setting.
To the top of the
date setting.
The meter turns
off.
NOTE
The meter turns
itself off if left
alone for 3
minutes (ECO
mode: 1 minute).
Your new settings
will be saved.
To the top of the
time setting.
To change
the date:
See steps 1 to
3 in “Date.”
OK
To the top of the
expiration
setting.
To the top of the
ECO mode
setting.
To the top of the
meal amount
setting.
To the top of the
result average
display setting.
Setup mode
1. Set the upper
limit of the
graph.
2. Set the lower
limit of the
graph.
20 to 600 mg/dL
10 to 590 mg/dL
Current setting
Bar graph
To the top of the
bar graph
setting.
1. Turn on the
HYPO flag.
2. Set the
threshold value.
10 to 80 mg/dL
A HYPO flag
appears when
your test results
are below the
threshold value.
Current setting
HYPO
(hypoglycemic)
To the top of the
HYPO setting.
Chapter 7 Meter Setup
Your meter is set up as below at the time of purchase. To change the settings, see the setup mode flowchart.
n
Alarm: Off
n
Beeper volume: High (3) n Date: Current local date
n
Time: Current local time
n
Result average display: 7d n Meal amount: Off
n
Bar graph: Upper limit 300 mg/dL, Lower limit 50 mg/dL
n
HYPO: Off
n
ECO: Off
n
Test strip expiration: Off