Abocom 802.11g Wireless Access Point WAP253 Quick Install Manual
802.11b/g Access Point
Quick Install Guide
Check for Packing List:
1
1
Hardware Installation
Notes
Before you starting hardware connection, you are advised to
find a appropriate location to place the Access Point. Usually,
the best place for the Access Point is at the center of your
wireless network, with line of straight to all your wireless
stations. Also, remember to adjust the antenna; usually the
higher the antenna is placed, the better will be the
performance.
Rese
t
LAN
2
LAN
1
DC
9V
-
+
-
-
Wire
le
ss
Acc
ess
P
oin
t
Po
we
r
Er
rS
tatu
s
Link
/Act
.
WEP
MA
C
Ct
rl
Br
idg
e
LA
N1
LA
N2
[ PC_WLAN ]
IP address: 192.168.1.xx
ESSID: 802.11g-AP
Channel: 11
Encryption: Disabled
Ethernet
UTP cable
To Ethernet network equipment,
e.g. Router, Switch, or another
Wireless Access Point
Power Adapter
DC 12V
[ Wireless Access Point ]
Default IP address: 192.168.1.254
SSID: 802.11g-AP
Channel: 11
Device name: Wireless AP
Encryption: Disabled
Wireless
LAN Card
Step 1. Connect to your local area network:
connect a
Ethernet cable
to one of the
Ethernet
port (LAN1 or
LAN2) of this Wireless Access Point, and the other end
to a hub, switch, router, or another wireless access point.
Step 2. Power on the device
: connect the included AC power
adapter to the Wireless Access Point's power port and
the other end to a wall outlet.
Check the LEDs:
¨
The
Power
and
LAN
#
LEDs should be ON. LAN# LED
will even blink if there is traffic.
¨
The
Link/Act
LED will blink if no client station is being
associated to this Wireless Access Point.
¨
If the
ErrStatus
LED glows, it means this Wireless
Access Point fails on self test. Please ask your dealer for
technical support.
Step 3. Configure your PC.
Make sure your local PC(s) has wireless network
adapter installed.
Check the LED:
¨
The Link/Act LED should be ON in static when your PC
associates to this Wireless Access Point.
In order to use the Access Point, other Wireless devices must
use
the same SSID and WEP settings
as the Wireless Access
Point.
The Wireless Access Point's default settings are as follows.
Wireless Access Point's default settings
Access Point Configuration
2
2
1.Start your computer. Connect an Ethernet cable between your
computer and the Wireless Access Point.
2.Make sure your wired station is set to the same subnet as the
Wireless Access Point, i.e. 192.168.100.12.
3. Start your WEB browser. In the
Address
box, enter the
following:
H T T P : / / 1 9 2 . 1 6 8 . 1 . 2 5 4
No username and password required for the first login (default setting).
However, you can assign a set of username and password for
future security.
4
M73-APO07-590
802.11g-AP