Accusplit Eagle 1620 Operating Instructions

WEARING YOUR PEDOMETER

While gently holding the belt clip open, slide the pedometer 

onto your belt or the top edge of your pants or skirt. It should 

fit snugly and level, above one knee. 

Note:

 The pedometer should be as vertical as possible. Walkers 

with larger stomachs may find it helpful to wear the pedometer 

farther back on the body, toward one hip. 

The cover must be closed for the pedometer to work. 

To avoid 

losing or dropping your pedometer, use the included leash and 

clip to fasten the pedometer securely to your clothing. 

Attaching the Leash: 

Attach the pedometer to the leash by 

looping the leash around the pedometer belt clip. Next, clasp the 

waistband of your clothing with the attached metal clip. You can 

also use a safety pin to fasten the leash to your clothing, loop 

the leash through your belt or belt loop, or use a badge holder. 

VIEWING YOUR RESULTS

Once you put on your pedometer with the cover closed, it will 

automatically begin to record your steps. 

ACTIVITY PEDOMETER

OPERATING INSTRUCTIONS

ACCUSPLIT, Inc.  •  6120 Stoneridge Mall Rd., Suite 210  •  Pleasanton, CA 94588 USA

800-965-2008  •  925-226-0888  •  FAX 925-463-0147  •  www.ACCUSPLIT.com  •  support@ACCUSPLIT.com

ACCUSPLIT®

       EAGLE

™

1620

Eat Right!  Walk More!  Live Well! 

The ACCUSPLIT Lifestyle

Congratulations on taking the first step to wellness with your purchase 

of an ACCUSPLIT pedometer. It’s easy to set up your new pedometer. 

Just follow the steps below, and start walking!

970-066

First, loop the 

pedometer clip

Next, loop the metal clip, 

then clasp clothing

Or, loop a  

badge holder, then 

 put into pocket

(Badge holder not included)

Or, loop a belt or  

belt loop

NO-PROOF-OF-PURCHASE LIMITED WARRANTY

See label inside the lid of the pedometer.

DISPLAY MODES

•   STePS: Counts steps taken since last ReSeT.  

  Reset daily to count each day’s steps.

AUTO MOVEMENT SENSOR

1.  To filter out random movements, the unit remains in standby mode until  

  5 continuous steps are registered. Only then are the 5 steps calculated in,  

  and an Active indicator “

▲

” appears on the upper left of display.

2.  When regular walk/run movement stops, after 2 seconds the timer pauses  

  and the unit switches to standby status (Active indicator “

▲

” disappears)

RESETTING YOUR PEDOMETER 

Most people prefer to reset step counts daily. To reset: Press and hold yellow 

ReSeT button for at least two seconds to reset to zero. 

REPLACING THE BATTERY

When the display starts to dim or goes blank, it is time to replace the battery. 

Your pedometer uses one Type LR43 (L1142) 1.5 volt alkaline battery. To 

replace:

1.  Insert a coin into the slot on the bottom of the case, and twist counter- 

  clockwise to loosen the case front. Lift case front away.

2.  Using a pen or other thin object, push battery sideways out of its holder.  

  Replace it with a new battery. The battery’s positive (+) terminal should  

  be FACe UP while you put it into the pedometer.

3.  Align case front over the pedometer and press gently to  

  snap cover back into place, starting with top.

ACCUSPLIT 

EAGLE 

1620

TW15MG

STEP

RESET

MY 

10K-A-DAY

™

425 I 

Yellow:

ReSeT

REGISTER NOW

Please return 

your AE1620 Registration to the 

Repair Center address in the 

warranty, and we will let you 

know about future products. 

Email (preferred)

User