Assembly and operating instructions animated lighting, inc. 13848 wyandotte kansas city, mo 64145 (816) 941-0400 www.Animatedlighting.Com with pumpkin faces in a box a product of animated lighting, l.C..
Overview congratulations! You have purchased the haunted house in a box (hhiab). It is a plug-and-play light controller from animated lighting that enables you to quickly build an exciting halloween light show with your lights on bushes and trees, black lights, strobes, spot lights or just about any...
Animated lighting, inc page 2 single pumpkin face package addressing: locate the two dials on the same board as the rj45 (8-pin) jacks that say a1 and a0 on them. These dials need to be set at “1” (a1) and “4” (a0). These dials will be changed based on the size of your display (the number of light c...
The single pumpkin face package has been pre-programmed based on the following: light channel description (recommendation) 0 top eyes 1 bottom eyes 2 top lip 3 mid lip 4 bottom lip 5 open mouth 6 circle mouth 7 black light 8 auxiliary bank 1, channel a 9 auxiliary bank 1, channel b 10 auxiliary bank...
Suggested layout - single pumpkin face package as long as you do not put too many lights into one channel, or overload the entire light controller, you can split zones across multiple objects. This means you can put two or more lights on an individual channel with the light controller. If you have m...
Animated lighting, inc page 5 1) connection: locate the rj45 (8-pin) jacks inside each of your light controllers. Connect one end of a cat 5 network cable into the open rj45 jack of your original controller. Run the other end of the cable out of the hole in the bottom of the box, and into a hole on ...
The four pumpkin face package with two controllers (controlling only the faces) has been pre-programmed based on the following (see below). Remember the controller for faces 1 and 2 are addressed at “1” (a1) and “4” (a0). Light channel description (recommendation) 0 top eyes, face 1 1 bottom eyes, f...
The standard lighting channels for the haunted house in a box has been pre-programmed based on the following (the network addresses of this controller are “0” (a1) and “0” (a0): suggested light arrangements - four pumpkin face package light channel description (recommendation) 1 flood light, channel...
Suggested layout - four pumpkin faces (continued) as long as you do not put too many lights into one channel, or overload the entire light controller, you can split zones across multiple objects. This means you can put two or more lights on an individual channel with the light controller. If you hav...
Setting up the base system this is the monster brain. Make sure it is located inside a building or a weather proof enclosure. Animated lighting, inc page 9 connect one end of the communications cable here. This is where the monster brain communicates with the external light controllers. Both plugs a...
A haunted house in a box light controller is rated for loads between 15 and 60 amperes maximum. Most household wall outlets are rated for loads of 15 amperes maximum. Therefore, unless you have specifically installed an outlet that can handle 30 amperes, you should locate two over-under outlets on se...
Support issues or for more details call: 816.941.0400 (9 a.M. To 5 p.M. Cst, m-f excluding holidays) email: support@animatedlighting.Com warranty and disclaimer please consult www.Animatedlighting.Com for product warranty and disclaimer information. Use for year-round the haunted house in a box can ...
