Anviz T50 Manual
Other Setup
Keypad Instruction:
C/
3
6
9
2
5
8
1
4
7
OK/M
0/
Operation Guide
Press the ‘Reset’ button at the buttom of the device until LCD go out.
Now release the button the device will restart.
Reset: Restarts Device
Management password setup: Press [0/→] to select [SET.] option: Change management password.
Setup Date and Time: Press [0/→] to select [TIME] option: Set time and date.
LCD
Fingerprint Sensor
Add User:
Management mode: In original state, press [OK/M] then enter the admin password (Default password：12345) to the management mode.
Notice: Resetting will not delete any information or settings stored
in the device.
Always place finger in the center of the sensor.
Make sure you cover the entire sensor surface
with as much of your finger as possible.
Do not place finger away from
the center of the sensor window.
Do not place finger
at an angle.
Correct method
(Straighten your finger and then place it on the sensor ensuring the finger is down flat and covers the entire sensor windows )
:
Incorrect method :
Do not slide your finger during the
fingerpint verification process.
Do not take off finger during the
fingerprint verification process.
Do not use just
your fingertip.
Illustration for placing finger
Reader Appearance
Press [OK/M]
Press [OK/M]
Press [OK/M]
SET
Input Date: YY-MM-DD
Set Time： HH-MM-SS
Press [OK/M]
Please Input password again
Press [OK/M]
SET
Reset Button
Initialization Button
To initialize the device and reset the management password back to the default
password (12345) press the ‘Initialization Button’ until heard beeps. The operation
will not delete any user data stored in the device.
Initialization: Return password to factory defaults
Remarks: If register fails, the device will
give a long ‘Beep’ voice to prompt. If the
fingerprint has already been registered
the device give two ‘beeps’ and voice
prompts for the fingerprint process to be
repeated.
Press【0/→】to
select FP1, FP2 or PW
Communication with PC
V1.3
Press[OK/M]
Management menu
Press [OK/M]
SET
Press [OK/M]
Press [OK/M]
SET
Input User ID to be deleted
Press [OK/M]
Delete User: Press [0/→] key select [DEL.] option.
Door Bell Key
Cancel/Power Key
Exit/Cancel the Current Operation
Power on/Power off
Confirm/Menu Key
Confirm Current Operation
Enter System Management Menu
Num. Keys
Enter Employee ID or Password
1-9
OK/M
0/
: Select Key
Do not move your finger before
the backlight of sensor turns off.
Press [OK/M]
Press [OK/M]
Press [OK/M]
The min&max password length is 1 to 6 digits
Press [OK/M]
Press [OK/M]
SET
Enter User ID
Press [OK/M]
Place same finger twice on the sensor
Registration Successful
Press [OK/M]
Place same finger twice on the sensor
Registration Successful
Input user password
Please input password again
RS485
Mini-USB
TCP/IP
RJ45
Default password:12345
Press [OK/M]
Remarks: If the second password does not
match the first. When you press
the device will give long beeps to indicate
the password changing has failed.
【
OK/M】
Input new management password
7
8
9
OK/M
1
2
3
c/
4
5
6
0/
144 mm
74 mm
40 mm
(Please verify administrator to enable
the USB communication)