Summary of IE-MediaChassis/2
Page 1
Ie-mediachassis/2 (dc) operation manual.
Page 2
Fcc radio frequency interference statement this equipment has been tested and found to comply with the limits for a class b computing device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated i...
Page 3
Original user only, is in lieu of any and all other warranties, express or implied, and all such warranties and indemnities are expressly disclaimed, including without limitation (i) the implied warranties of fitness for a particular purpose and of merchantability and (ii) any warranty that the prod...
Page 4
Table of contents fcc radio frequency interference statement .................................................. Ii warranty ............................................................................................................. Ii about the ie-mediachassis/2 (dc)..................................
Page 5
About the ie-mediachassis/2 (dc) the ie-mediachassis/2 (dc) is a stand-alone chassis for use with imcv modules. As an unmanaged chassis, the ie-mediachassis/2 (dc) supports two single-wide or one dual-wide imcv module. All imcv modules, with the exception of the snmp management card, will function p...
Page 6
The rack-mount shelf is sold separately. To purchase the rack-mount shelf (part number 895-39949); visit the b&b electronics’ product accessories page: www.Bb-elec.Com rackmounting requires a rackmount shelf for mounting up to three units side by side. 3. If mounting the chassis on a wall, place two...
Page 7
Configuring and installing modules b&b electronics recommends turning the chassis power off before proceeding. 1. To install an imcv module, slide the module into the chassis until the module is firmly seated in the backplane. 2. Secure the module to the chassis by tightening the captive thumb screw...
Page 8
1. This equipment shall be connected directly to the dc supply system earthed electrode conductor or to a bonding jumper from a grounded terminal bar or bus to which the dc supply system grounding electrode conductor is connected. 2. This equipment shall be located in the same immediate area (such a...
Page 9
Dc power supply precautions the following precautions must be observed when installing the chassis model with an internal dc power supply. 1. Check nameplate ratings to ensure there is no overloading of supply circuits that could effect over current protection and supply wiring. 2. In addition, the ...
Page 10: International Headquarters
B&b electronics technical support international headquarters b&b electronics mfg. Co. Inc. 707 dayton road ottawa, il 61350 usa phone (815) 433-5100 -- general fax (815) 433-5105 website: www.Bb-elec.Com european headquarters b&b electronics westlink commercial park oranmore, co. Galway, ireland pho...
Page 11
Electrostatic discharge precautions electrostatic discharge (esd) can cause damage to your add-in modules. Always observe the following precautions when installing or handling an add-in module or any board assembly. 1. Do not remove unit from its protective packaging until you’re ready to install it...
Page 12
Safety certifications ul/cul: listed to safety of information technology equipment, including electrical business equipment. Ce: the products described herein comply with the council directive on electromagnetic compatibility (89/336/eec) and the council directive on electrical equipment designed fo...
Page 13
? 2013 b&b electronics. All rights reserved. The information in this document is subject to change without notice. B&b electronics assumes no responsibility for any errors that may appear in this document. Ie-mediachassis/2 is a trademark of b&b electronics. Other brands or product names may be trad...