Boltzero bunk bed assembly instructions - please keep for future reference important - please read these instructions fully before starting assembly if you need help or have damaged or missing parts, call the customer helpline: argos = 0345 640 0800 issue 1 - 31/07/15 dimensions width - 2010mm depth...
1 • check you have all the components and tools listed on the following pages. • remove all fittings from the plastic bags and separate them into their groups. • keep children and animals away from the work area, small parts could choke if swallowed. • make sure you have enough space to layout the p...
2 components - parts please check you have all the parts listed below back left end post 1 front left/back right end post 2 front right end post 3 upper side rail x 2 4 lower side rail x 2 5 lower front rail 6 lower back rail 7 ladder 8 if you have damaged or missing components, call the customer he...
3 components - fittings please check you have all the fittings listed below tools required footing x 4 note: the quantities below are the correct amount to complete the assembly. In some cases more fittings may be supplied than are required. A long cap x 16 b short cap x 11 c washer x 4 d rubber mal...
4 assembly instructions step 1 step 2 attaching footings attach footings to end posts , and as shown. Attaching lower side rails with the help of an assistant holding the end posts, attach the lower side rails to the end posts as shown. Insert into holes on the end posts first then push down the sid...
5 assembly instructions step 3 step 4 attaching upper side rails attach the upper side rails (4) to the end posts as shown. Insert into holes on the end posts first then push down the rails to lock. Attaching lower rails attach the lower front rail (6) and lower back rail (7) to the end posts (1) an...
6 assembly instructions step 5 step 6 attaching right hand end panel attach the lower front rail (6) and lower back rail (7) to the other end posts (2) and (3) as shown. Insert into holes on the end posts first then push down the rails to lock. Attaching upper back safety rail attach the upper back ...
7 assembly instructions step 7 step 8 6 6 8 8 2 3 3 8 8 9 9 9 d d d d d d attaching ladder attach the ladder (8) into holes on washers and the lower front rail (6) as shown. Note: make sure to position the ladder with the arrow sticker on the ladder pointing up. 6 8 d attaching upper front safety ra...
8 assembly instructions step 9 step 10 attaching upper slats note: before attaching the slats , carefully make adjustments to ensure the bed frame is straight. Note: position the horizontal rail below when attaching the slats onto the bed. Starting on one end, attach the slats one by one into upper ...
9 assembly instructions step 11 attaching caps attach long caps and short caps into holes on the end posts as shown. Insert and lock it carefully into holes by using a rubber mallet. C c c b b b 9 9 if you need help or have damaged or missing parts, call the customer helpline: argos = 0345 640 0800 ...
A guide to - wall mounting & fixings revision 2 - 7/10/09 important note: types of walls care & maintenance no.1 “general purpose” wall plug no.6 “shield anchor” wall plug heavy loads no.3 “cavity fixing” wall plug no.4 “cavity fixing-heavy duty” wall plug no.5 “hammer fixing” wall plug no.2 “plaste...
Use the metal slats pusher to remove the slats as shown in the diagram. Insert it into the front/back/safety rails then pull it until the slats is detached. 11 11 10 9 6 7 f 10 11 f 10 11 guide to disassembling the slats metal slats pusher (provided) please keep this tool for future use. Tools requi...
