1. DL manuals
  2. B.M.C.
  3. Amplifier
  4. CS2
  5. Owner's Manual

B.M.C. CS2 Owner's Manual

Summary of CS2

  • Page 1

    Power dim input volume power dim input volume opto control in loop out cs2 stereo power amplifier right channel right speaker left channel left speaker serial no.: input input phase ac power 50/60hz xlr-1 xlr-2 xlr-1 xlr-2 rca-2 rca-3 rca-1 rca-2 b.M.C. Audio made by b.M.C. Germany weee - reg. - nr....

  • Page 2

    B.M.C. Audio gmbh germany www.Bmc-audio.Com info@bmc-audio.Com introduction front panel functions rear panel functions input selection and display digm volume adjustment and display remote control troubleshooting, maintainance, service important safety information general safety precautions ce / fcc...

  • Page 3

    Power meter in watt and db power meter in watt and db the stereo power meter displays the output power in watt at 4-ohm speakers, and in db relative to 1 watt. Since these electro-mechanical instruments are innately too slow for music pulses, an electronic circuit analyzes the signals at the speaker...

  • Page 4

    Power dim input volume cs2 ac power cable remote control rc1 digm optical waveguide owner's manual please keep the packing for eventual later transportation. In classical integrated amplifier mode by default all inputs are operating traditionally and are compatible to any source component. In case o...

  • Page 5

    Opto control in loop out cs2 stereo power amplifier right channel right speaker left channel left speaker serial no.: input input phase ac power 50/60hz xlr-1 xlr-2 xlr-1 xlr-2 rca-2 rca-3 rca-1 rca-2 b.M.C. Audio made by b.M.C. Germany weee - reg. - nr.: de18339144 rca-3 rca-1 ce declaration of con...

  • Page 6

    Select input by pressing the input switch on the front of the cs2, or the in- up/down buttons of the remote control rc1, amp section. The selected input is displayed in the meter window of the cs2. During the switching procedure the music signal will be faded down and up again, thus avoiding hard sw...

  • Page 7

    Amp cs2's amplification (gain) can be selected by turning the volume knob or by remote control, not as usual by attenuating the input level, but by setting the gain lossless according to the actual requirements. The digm setting is always “10" after power off / on, for having a safe volume protectin...

  • Page 8

    Rc-1 dac cd in amp vol vol in df ovs ups +10 0 9 8 7 6 5 4 3 2 1 clear check prog disp rep. Mute mute use the amp section on top of rc-1 for the classical amplifier mode volume + increase the sound volume volume - decrease the sound volume mute mutes the signal. Unmute by pressing mute again. Mute w...