I nstallation , operating and servicing instruction manual l 900 s eries o ven r ange model no‟s.: l 900-4, l 900-5, l 900-6 aga approval no.; 4921 b&s commercial kitchen appliances pty ltd 57 plateau road reservoir vic 3073 australia tel: +61 3 9469 4754 fax: +61 3 94694504 web: www.B-scka.Com.Au p...
Table of contents installation, operating and servicing instruction manual ................................... I l 900 series oven range ................................................................................ I product specifications ............................................................
Replacing/servicing oven thermocouple lead ...................................................................... 14 replacing/servicing oven pilot burner ................................................................................... 15 aeration of oven burner .....................................
L 900 series oven range (aga no. 4921-07) april 2011 4 p roduct s pecifications appliance name: l 900 series oven range manufactured by: b&s commercial kitchen appliances pty ltd 57 plateau road reservoir victoria 3073 tel; + 61 3 9469 4754 fax: +61 3 9469 4504 e-mail: b.Scka@optusnet.Com.Au model n...
L 900 series oven range (aga no. 4921-07) april 2011 5 important warnings this appliance shall only be installed/serviced by an authorised installer. This appliance must be installed in accordance with the specified instructions and specifications. Improper installation or operation of this applianc...
L 900 series oven range (aga no. 4921-07) april 2011 6 table 2: a ppliance d imensions model: l 900-4 l 900-6 width (mm): 600 600 depth (mm): 840 840 height (mm): 1,100 1,100 working height (mm): 900 900 figure 1: p lumbing c onnections table 3: p lumbing c onnections connection position from floor ...
L 900 series oven range (aga no. 4921-07) april 2011 7 i nstallation i nstructions r egulations the appliance must be installed only by authorised persons and in accordance with the manufacturer‟s installation instructions, local gas fitting regulations, municipal building codes, as 5601 – gas insta...
L 900 series oven range (aga no. 4921-07) april 2011 8 before connecting new pipe to this appliance, the pipe must be blown out thoroughly to remove all foreign material. Foreign material in the burner and gas controls will cause improper and dangerous operation. Connect to gas. P ressure test point...
L 900 series oven range (aga no. 4921-07) april 2011 9 c. Turn control knob clockwise to the „high‟ position. Examine flame. D. Turn control knob clockwise to the „off‟ position. E. Repeat steps a to d for all burners. Adjusting aeration of boiling top burner (if required) always use caution when re...
L 900 series oven range (aga no. 4921-07) april 2011 10 o perating i nstructions warning! Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not store or use flammable liquids or items in the vicinity of this appliance. Prior to lighting, smell the area surrounding ...
L 900 series oven range (aga no. 4921-07) april 2011 11 f igure 2: c ontrol p anel – b oiling / c ooktop s ection f igure 3: c ontrol p anel – o ven s ection l ighting i nstructions boiling top burners - models with pilot and/or flame failure 1. Ensure the control knob is in the „off‟ position. If n...
L 900 series oven range (aga no. 4921-07) april 2011 12 knob and turn clockwise to the ‘off’ position. Wait for five minutes before attempting to re-light (repeat steps 1-3). 4. Adjust the size of the flame as required by turning knob clockwise. Oven 1. Open the oven door and keep it open until the ...
L 900 series oven range (aga no. 4921-07) april 2011 13 lids are dried prior to replacing onto lower part of burner. While upper lid is soaking, clean lower part of burner with a clean damp cloth soaked in a mild detergent. Y early c hecks & s ervice the appliance should be inspected and adjusted pe...
L 900 series oven range (aga no. 4921-07) april 2011 14 a. Remove front burners by lifting the burner at the rear, and then slowly pulling it towards the splash back (rear) of the appliance off the injector. B. Adjust the interrupter screw located at the top end of the venturi section as required (c...
L 900 series oven range (aga no. 4921-07) april 2011 15 3. Release the thermocouple head from the pilot assembly inside the oven. 4. Pull out the thermocouple lead from the top. 5. Reassemble in reverse order. R eplacing /s ervicing o ven p ilot b urner to replace the pilot burner: 1. Undo the union...
L 900 series oven range (aga no. 4921-07) april 2011 16 c. Undo the screw holding the pilot assembly to the inlet of the oven burner. D. The pilot assembly can then be lifted out. E. Change pilot injector spud with correctly sized injector refer table 1: nominal terminal input rates & injector sizes...
L 900 series oven range (aga no. 4921-07) april 2011 17 pilot light not establishing positioning of thermocouple faulty thermocouple faulty flame failure control valve check connection of the thermocouple to the control is not loose. Adjust positioning of thermocouple to ensure pilot flame is hittin...
L 900 series oven range (aga no. 4921-07) april 2011 18.
