B-Speech B-Speech Prim Manual - 8 Maintenance
15
7.2.2 Releasing the Eagle
DS
Runner from the safety rail
a) Pull out the plunger and rotate the lever downwards to the horizontal
position (see images below).
b) Press and hold the push button.
c) Open the runner by pressing the push button and by pulling apart both
body sides of the runner simultaneously (see image below).
d) Remove the runner from the safety rail.
8.1 Cautions
a) Keep all the parts free of oil, grease, paint, aggressive chemicals
and alike.
b) Clean the shock absorber using a weak sulpho-solution and a soft
brush. Subsequently, flush it with plenty of pure water.
c) Never place liquids or sharp objects in the vicinity of the FPS as
these might damage it.
d) If the FPS gets wet, dry the runner and the safety rail with a dry
cloth. Let the shock absorber air-dry naturally. Do not use any kind of
heating.
8.2 Storage
a) Store the runner system out of direct sunlight and protected from
heat and dust.
8.3 Annual inspection
a) At least every 12 months, a certified technician shall inspect the
FPS (both runner and rail). Otherwise, the warranty will be void and
AVANTI will renounce all liability and claims that may appear.
The annual inspection may only be conducted by a certified
technician.
The annual inspection shall be carried out following the inspection
procedure. During the inspection, the “Annual Inspection Check-
list” Appendix and the “Inspection log sheet” Appendix shall be
filled in for future reference.
b) During this inspection, special attention shall be paid to the safety
rail and the runner
8.4 Inspection procedure
8.4.1 Ladder rungs
a) Ensure that no dents, holes, or cracks have any influence on the
rung stability.
b) The dents shall not exceed 10 mm in diameter or be more than 1
mm deep.
c) If dents are found on the rung edges or corners, the step stability
can no longer be guaranteed. In such case, replace the ladder section.
8 Maintenance
STOP
STOP
Caution!
The locking lever is only to be used when locking or unlock-
ing/releasing the runner. In all other situations the locking
lever shall be kept in locked position fixed with the plunger
locked in the runner body.
MASTER 47840008 EN_CORREGIDO.indd 15
25/10/17 12:01