High performance amplifiers owner's manual.
Features circuit configuration frequency response signal to noise ratio input sensitivity input level selector crossover high pass filter low pass crossover range subsonic crossover range bass boost phase output master / input slave remote control damping factor power terminal gauge b2 series output...
Input connect preamp signal cables from the headunit to rca input of mono . Output output rca for signal routing to another amplifier. Power & protection indicator power blue, green-lit shows correct operation protect led, red-lit shows general malfunction, faulty connection or thermal protection ga...
Rem ( remote ) connect to switched +12v with trigger from head unit. Speaker outputs amplifier connection to loudspeakers. Minimum speaker cable is 12 gauge. Mono minimum impedance is 1 ohm if used as a single unit. Mono in linked mode offers stable opearation to a minimum of 2 ohms. Quattro minimum...
Fuse 180a ground remote turn on main battery 12v headunit +12v, gnd, rem connection diagram for safety purposes, install the amplifier in a dry and well ventilated location and make sure no cables or other harness of the car is interfaced with the mounting location or will present a hazard to the ca...
Caution mono minimum impedance is 1 ohm. Or mono linked minimum impedance is 2 ohm mono speaker connection diagram i 4-4. Speaker connection b2 amplifier series recommends 12 awg speaker connecting cables. Run 12 awg speaker connecting cables from your speakers to amplifiers' mounting location keep ...
Tweeter passive midrange /bass passive midrange /bass tweeter tweeter 8 ohm ~ 4ohms passive midrange /bass 8 ohm ~ 4ohms passive tweeter midrange /bass passive midrange /bass tweeter quattro speaker connection diagram i quattro speaker connection diagram ii quattro speaker connection diagram iii 6.
Headunit mono master amplifier 4-5. Mono daisy chain connection daisy chain connection allows linking of 2 mono amplifiers to work as 1. Step 1 . Connect the master mono amplifier to the head-unit and set its output master step 2 . Connect the master and slave mono amplifier in daisy chain rca jack ...
Mono minimum daisy chain connection impedance is 2 ohm do not use daisy chain connection in 1 ohm mono working voltage is 9v ~ 16v. Caution fuse 360a main battery 12v headunit ground 8 8 ohm ~ 2ohms.
5. Trouble shooting tips no sound ( no output ) terminals to see if there is any movement of the speaker cone. Protection quattro minimum working impedance is 2 ohm stereo or 4 ohm mono voltage lower than 8.5v or higher than 16v will cause the amplifier to go into protect. Check whether b2 series am...