Bacsa ACS-Z User Manual

Summary of ACS-Z

  • Page 1

    Scale acs-z user manual versiÓn 12.11.06.

  • Page 2

    VersiÓn 12.11.06 index specification..................................................................................... Pag. 3 keyboard instruction............................................................... Pag. 3 operation..........................................................................

  • Page 3

    VersiÓn 12.11.06 1. Specification: 1.1. Rechargeable accumulator inside, you can use the scale during recharging. 1.2. Auto zero-setting when switch on the scale. 1.3. Auto zero-tracing. 1.4. Switch among weighing, counting, percentum. Function of choosing weight range. 1.5. Power supply: ac 220v (±...

  • Page 4

    VersiÓn 12.11.06 3. Operation: the scale must to be placed on the stable and flat surface, adjust its four screw carrier pole to horizontal, switch on the power. The scale cannot be used for a long time under tare state or the function of zero tracing will disappear and the zero will move. The scale...

  • Page 5

    VersiÓn 12.11.06 press【set】 to exit from the setting state when in the process of setting. The set value is invalid. 3.2. Counting mode press【 set】 to sample weight in the counting model. It displays “sap x” (x is the sample number). 1. Press 【 ↑ 】 to press 【e nter】 to m ake sure. 2. The weight wind...

  • Page 6

    VersiÓn 12.11.06 3.4. Calibration keep pressing【 cali.】 for about 4 seconds. Calibrate after the weight window displays “cal.”. There are two ways to calibrate: 1. Full range load: put enough weight on the platform according to the full scale. Press【e nter】 to make sure. Calibration finished. 2. Ran...

  • Page 7: Stb

    VersiÓn 12.11.06 5. If it display “-sys-” when you switch on the scale please re-calibrate or send it to repair. If it display –set--”, it means the alarm setting is wrong, please reset the alarm value. 5. Rs232 transmission method: 5.1. Rs232 setting press 【mode l】 and 【 tare】 key when self-testing...

  • Page 8

    VersiÓn 12.11.06 5.2. Interface rs232 5.2.1. Frame format: the scale have a standard rs232 uart signal, each data frames has 10bits.The detail information of frames is as follows: bit 1 bit 2 bit 3 bit 4 bit 5 bit 6 bit 7 bit 8 bit 9 bit 10 bit1 : start bit bit2~bit9 : data bit bit10 :stop bit 5.2.2...