- DL manuals
- Bad Boy
- Lawn Mower
- CZT
- Owner's, Service & Parts Manual
Bad Boy CZT Owner's, Service & Parts Manual
Summary of CZT
Page 1
Zero-turn mower owner’s, service & parts manual for additional information, please see us at www.Badboymowers.Com bad boy, inc. 102 industrial drive batesville, arkansas 72501 (870) 698-0090 outlaw extreme & outlaw.
Page 2: Table of Contents
Table of contents basic information ........................................................................................... Section 1 (pages 4–5) bad boy safety guidelines ............................................................................. Section 2 (pages 5–6) operation .................
Page 3
This manual applies to the following equipment: bad boy outlaw series outlaw 5400 54˝ 30hp briggs pro outlaw 5400 61˝ 30hp briggs pro outlaw extreme 5400 54˝ 31hp kawasaki outlaw extreme 6100 61˝ 31hp kawasaki outlaw extreme 7200 72˝ 31hp kawasaki outlaw extreme 6100 61˝ 36hp vanguard outlaw extreme...
Page 4: Section 1:
Section 1: basic information congratulations on the purchase of your new bad boy mower! The purpose of this manual is to assist operators in maintaining and operating their machine. The information and instructions in this manual can help you attain years of performance from your new bad boy. Also, ...
Page 5: Section 2:
Section 2: mower safety guidelines never allow untrained people to operate this machine. It is the owner’s responsibility to get training and see to it that anyone who has permission to use your machine receives the proper training. Do not mow around people. The factory discharge chute is designed t...
Page 6: Section 3:
2.23 safety warning decals are located on the mower and should always be observed and followed. 2.24 never operate the mower with the discharge chute open. 2.25 prevent fires—remove grass and debris from engine compartment and muffler area, before and after operating machine, especially after mowing...
Page 7: Section 4:
3.9 increase rpm by sliding the throttle to fast position, toward the rabbit. 3.10 owners must become familiar with the controls before operating a zero-turn radius vehicle. 3.11 start slowly and build your skill level. Have ample practice before using the machine at full capabilities. 3.12 be comfo...
Page 8: Section 5:
Section 5: mower storage & transportation 5.1 keep machine from collecting debris by storing in a covered area while not in use. 5.2 fuel can harm your machine if left for more than 30 days without changing, especially if the fuel contains ethanol. Never use fuel with more than 10% ethanol by volume...
Page 9: Section 7:
6.5 q: do you offer touch-up paint for your mowers? 6.5 a: touch-up paint is available. Contact your local dealer for more information. 6.6 q: how durable is the electric deck lift? 6.6 a: the actuator which controls the deck height is designed for moving loads of up to 1000 pounds and has a static ...
Page 10: Section 8:
Section 8: moving inoperable mower 8.1 do not tow machine. Use a winch to load on a trailer for transporting. 8.2 attention: return bypass valves to operating position before running mower following repairs. 8.3 outlaw models are equipped with two neutral engage/disengage arms, located at the rear o...
Page 11: Section 10:
Section 10: mower blade maintenance 10.1 check mower blades after each use. This is essential for maintaining well-groomed turf. Keep the blades sharp. If a dull blade is used for cutting, the grass will tear rather than cut. This could damage the grass leaving a brown frayed top on the grass within...
Page 12
How to choose the right blade essentially there are only two basic styles of mowing blades used or approved for use on our current products: 1) the standard style of mowing blade is essentially designed for cutting grass and effectively discharging the clippings out from the deck to fall onto the la...
Page 13: Service Section
Service section section 1: hydrostatic system the hydro overflow tank on the outlaw model is located behind the seat. Notice the “full cold” line at the bottom of the tank. Use only 20w50 motor oil in this tank. Conventional or synthetic oil may be used. When servicing a mower with a sealed transaxl...
Page 14: Section 2: Drive Belt
The check plug is located at the top center of the inside case of each transaxle (outlaw transaxles have this plug on the top). The transaxle can be filled with oil by removing these check plugs from both transaxles and pouring the oil in the hydro overflow tank, located behind the seat. Oil will be...
Page 15: Section 3: Engine
Section 3: engine most models have a drain hose installed on the engine, for easier oil changes. All gas engines used by bad boy use 10w30 and have an oil capacity of 2 quarts. Bad boy recommends that the oil and filter be changed every 50 hours of usage. The fuel filter is located in the fuel line ...
Page 16: Section 4: Electrical System
Section 4: electrical system on most larger commercial engines (27 hp and up), the 25 amp main fuse is located about 3” from the starter on the engine. (shown in first image on right). On smaller commercial and light duty commercial mowers, the 25 amp main fuse is located just behind the battery con...
Page 17
Page 17.
Page 18: Section 5: Frame
Section 5: frame for non-suspension models, torque front fork castle nut to 40 ft.Lbs. Be sure to spin the fork while torquing the nut to ensure that no bearing damage is done. Be sure to reinstall the cotter pin into the castle nut. Always try to go tighter on the nut to find a castellation for the...
Page 19: Section 6: Cutting Deck
The pump belt tensioner is located under the engine and has a grease fitting at its pivot point. Grease at every engine oil change. The deck belt tensioner is located at the rear of the deck and has a grease fitting on its pivot point. Grease at every engine oil change. The control arm blocks have g...
Page 20
The large turn buckles on the front of the deck only affect the pitch of the deck or the level from front to back. The deck spring tension is critical. If the tension is too much, it will cause the spring to break. If too loose, the belt can jump off or slip on the pulleys and cause a cut quality is...
Page 21: Mowing Tips:
Mowing tips: • mow header strips at the ends of the lawn and around flower beds first. Make them wide enough that you can turn the mower around in the already mown section. Then mow back and forth between these header strips overlapping each lap by about 1/8 the width of the mower’s deck. • don’t cu...
Page 22: Parts Section
Parts section page 22.
Page 23
Outlaw page 23.
Page 24
Outlaw extreme page 24.
Page 25
Page 25.
Page 26
Page 26.
Page 27
Page 27.
Page 28
Page 28.
Page 29
Page 29.
Page 30
Page 30
Page 31
Page 31.
Page 32
Page 32.
Page 33
Outlaw page 33.
Page 34
Outlaw extreme page 34.
Page 35
Page 35.
Page 36
Page 36.
Page 37
Page 37.
Page 38
Page 38.
Page 39
Page 39.
Page 40
Page 40
Page 41
Page 41.
Page 42
Page 42.
Page 43
Page 43.
Page 44
Page 44.
Page 45
Page 45.
Page 46
Page 46.
Page 47
Page 47.
Page 48
Page 48.
Page 49
Page 49.
Page 50: 2011 Limited Warranty
2011 limited warranty for bad boy commercial mower (aos, czt, diesel, lightning, outlaw, and pup series) 1. What this warranty covers, and for how long: bad boy, inc. Will, at its option, repair or replace, without charge, any part covered by the warranty which is found to be defective in material a...
Page 51
Bad boy, inc. 102 industrial drive batesville, ar 72501 1.866.622.3269 www.Badboymowers.Com technical support: brad covington ................................................................. Brad.Covington@badboymowers.Com bill hurst ....................................................................
Page 52: Www.Badboymowers.Com
For additional information, please see us at www.Badboymowers.Com bad boy, inc. 102 industrial drive batesville, arkansas 72501 (870) 698-0090