Bad Boy Xtreme MJ Installation And Operation Manual

Manual is about: Hi-Power B/G/N Wi-Fi Antennas

Summary of Xtreme MJ

  • Page 1

    X treme installation and operation guide revision: 1.3 getting you on the web hi-power b/g/n wi-fi antennas x treme.

  • Page 2

    Bitstorm inc. Bad boy xtreme n & mj 2 www.Bitstorm.Com important before you install your system your bad boy wi-fi system has been completely tested prior to shipment going through multiple individual and system verifications including wi-fi connectivity. Before cutting your cable or installing your...

  • Page 3

    Bitstorm inc. Bad boy xtreme n & mj www.Bitstorm.Com 3 package contents please check and ensure that you have all of the following items: 1 bad boy xtreme n or mj hi-power wi-fi device 1 poe injector with dc power cable, optional 100-250vac adapter 1 antenna with mounting nut (discard washed if indi...

  • Page 4: Chapter 1 - Bench Test

    Bitstorm inc. Bad boy xtreme n & mj 4 www.Bitstorm.Com chapter 1 - bench test check off items as completed. Step 1 remove the protective cap from antenna connector and attach to xtreme. Finger tight is adequate. Do not over tighten. Step 2 (do this step if an optional unleashed is included) duo come...

  • Page 5: Step 4

    Bitstorm inc. Bad boy xtreme n & mj www.Bitstorm.Com 5 step 4 remove bottom cover from xtreme and plug in 75 ft (23m) black cable. Plug other end of cable into poe adapter port 1. See illustration on page 3 for location. Note: xtreme requires power to operate and should be connected to port 1 which ...

  • Page 6: Chapter 2 - Installation

    Bitstorm inc. Bad boy xtreme n & mj 6 www.Bitstorm.Com proceed with remainder of installation only after correct operation has been determined. Chapter 2 - installation disconnect power. Determine the best location for the unit. It can be any place con- venient or suitable with better being higher a...

  • Page 7

    Bitstorm inc. Bad boy xtreme n & mj www.Bitstorm.Com 7 route the remaining cable to the location where the power adapter will be. To prevent connector contact corrosion, apply corrosion inhibitor (included under end cover) sparingly to the contacts of the device cable end connect- or. Note: a thin c...

  • Page 8: Chapter 3 - Operation

    Bitstorm inc. Bad boy xtreme n & mj 8 www.Bitstorm.Com connect to a power source: ac adapter or dc power cable. For power cable: red (or white stripe) is positive(+) and solid black is negative(-). For dc voltage limitations, refer to your included power adapter for input volt- age requirements. Obs...

  • Page 9: Step 3

    Bitstorm inc. Bad boy xtreme n & mj www.Bitstorm.Com 9 step 3 refer to fig 2. On the link setup tab, select the country that you are in as required [1]. Select a hotspot from the list [2] or enter an access point name into the hotspot name field [3]. Enter any security infor- mation required to the ...

  • Page 10: Step 4

    Bitstorm inc. Bad boy xtreme n & mj 10 www.Bitstorm.Com step 4 when apply has completed, the status tab will be displayed. Connec- tion progress will be reported. You may see status of ’connecting’, ‘authenticating’, ‘obtaining ip address’, etc. See fig 3. Note: if connecting to an unsecured hotspot...

  • Page 11

    Bitstorm inc. Bad boy xtreme n & mj www.Bitstorm.Com 11 appendix a - specifications output power with antenna: up to 36 dbm (4w) eirp max receiver sensitivity: up to -96 dbm wireless range: line-of-sight, >5 miles (>8 km) operating temperature: -40°f to +176°f (-40°c to +80°c) operating humidity: 5 ...

  • Page 12: M-Poe-Duo-S15.5

    Bitstorm inc. Bad boy xtreme n & mj 12 www.Bitstorm.Com appendix c - power injector duo specifications m-poe-duo-s15.5 injector power input: 5-30 vdc injector power output: 15.5 vdc, 1a max output ripple: output short circuit protected: yes – protection circuit limited to 5a max power reverse polari...

  • Page 13

    Bitstorm inc. Bad boy xtreme n & mj www.Bitstorm.Com 13 appendix f - troubleshooting appendix e - computer ethernet port settings accessing the settings for your computer’s ethernet port are described here for various operating systems. Please keep in mind that as revisions to operating systems are ...

  • Page 14

    Bitstorm inc. Bad boy xtreme n & mj 14 www.Bitstorm.Com into the browser’s address bar. Refer to chapter 3 - operation. 3. Multiple wi-fi devices. If system does not include optional unleashed, ensure the computer’s built-in wi-fi is turned off. Refer to your computer’s manual. 4. Incorrect xtreme u...

  • Page 15

    Bitstorm inc. Bad boy xtreme n & mj www.Bitstorm.Com 15 warranty 1. All bitstorm products are warranted against defects in material and workmanship for a period of one year from date of purchase under normal use. Warranty does not cover damage caused as a result of improper installation or operation...

  • Page 16: Backstay Mount

    Standard marine 1-14 adapter mount the 1-14 antenna adapter allows xtreme to be mounted onto a standard 1" x 14 pitch threaded antenna fitting. Satin finish anodized aluminum. Not compatible with xtreme . Backstay mount mount xtreme onto a backstay. The angle of backstays does not vary significantly...