Bak thermoplastic welding technology ag 1 operating manual.
Bak thermoplastic welding technology ag 2 safety danger to life unplug the tool before opening it as live components and connections are exposed. Danger of fire and explosion in case of incorrect use of the hot wedge welder, espe- cially near combustible materials and/or explosive gases. Danger of b...
Bak thermoplastic welding technology ag 3 intended use the comon is an automatic hot wedge welding machine for overlap welding and for manufac- turing of films and geomembrane liners in tunnels as well as in earthwork and civil engineering. Heating system: the wedge temperature is stepless adjustabl...
Bak thermoplastic welding technology ag 4 cutaway model of a test channel with overlap welding according to dvs 2225 welding parameters welding temperature set the welding temperature with the up – down keys of the temperature controller positioned on the left of the front panel. The switch on - off...
Bak thermoplastic welding technology ag 5 welding welding preparation laying of material: o width of overlap from 80 to 140 mm o make sure that the surfaces of geomembrane liners, above and below, are cleaned, as well as between the overlap. Mains supply at least 3kw (generator) supplied with an rcc...
Bak thermoplastic welding technology ag 6 adjusting the hot wedge the hot wedge can be adjusted depending on the material thickness. By cold wedge, engage the welding machine onto the geomembrane to be welded. Engage the wedge onto the geombembrane. Lower the pressure lever after the needed pressure...
Bak thermoplastic welding technology ag 7 assistance and support the bak group and its authorised service centres offer free support and assistance in the area of applications technology. Our specialists will be pleased to help you. Customer service and orders: bak thermoplastic welding technology a...
Bak thermoplastic welding technology ag 8 transport – handling – storage transport: the welding machine is packed appropriately and must be protected from moisture. Handling: the shipment must be checked if complete and for transport damage. In the event of transport damage, the defect must be confi...
