Led weather station with 433 mhz remote sensor user’s manual.
Introduction congratulations on your purchase of this new weather station with led display. This unique product is designed for everyday use for the home or office and is a definite asset of great use. To fully benefit from all the features and understand the correct operation of this product, pleas...
Stormy. D. Low battery indicator it is to indicate the backup battery in the main unit when the battery power level is low. The user needs to change the batteries at once. Otherwise, the clock and alarm setting will be reset if the plug-in adaptor is disconnected. E. Clock time display current time ...
- toggle to display the max/min reading of the indoor & remote temperature. - press & hold for 2 seconds to clear the memorized max/min readings of the indoor channel or the selected remote channel. 3. [menu/setup] button press and hold 2 seconds to enter clock setting mode 4. [ch] button - select a...
Close the battery compartment of outdoor sensor. The transmission led on the front of the outdoor sensor will start to flash for 10 seconds. The default flashing frequency is once per around 2 seconds to indicate this sensor will be registered on channel 1 if not set manually within 10 seconds. Whil...
Adaptor, the led weather station will turn off the display, save the last reading of the temperature and weather forecast; keep running the internal clock with the backup battery. The led weather station will start rf searching mode for 2 minute after plug in the adaptor. Transmission range the maxi...
Dcf 77 radio controlled clock the remote sensor receives the time signal transmitted by physikalisch-technische bundesanstalt (ptb) of germany, which is regulated by 4 atomic clocks and in average deviates less than 1 second in 2 million years. Ptb transmits the time signal (dcf77, 77.5khz) continuo...
] button to decrease by one hour to the desired hours. Holding down the button will initiate the fast increments/decrements. Press the [ ] button to confirm. 5. The minute digits will be flashing. Use the [ ] button to increase by one minute or the [ ] button to decrease by one minute to the desired...
How to display max/min temperature press the [max/min] button to display the memorized maximum indoor and outdoor temperature on the channel displayed for 6 seconds. Press this key again to display the memorized minimum indoor and outdoor temperature on the channel displayed for 6 seconds. While the...
