BALCO HE180021 Instruction Manual - page 20

20

.

3.1 Unboxing and Assembly

Your Balco 3D Printer Touch is packed tightly and carefully - take your time unpacking it. 

To view a step by step video of the Unboxing and Assembly, visit balcolifestyle.com 

1. 

Carefully remove the Extruder Tower and Heated Print Bed from the 

box and place them on a clean, level work space. Slot the rubber feet 

onto all 4 corners of the Heated Print Bed Base, and one on both sides 

of the Extruder Tower Base. Carefully remove the cable tie that holds 

the Extruder in place

NOTE: Raise the Extruder by gently pulling the z-axis rod towards the top of the 

Extruder Tower and move the Extruder to one side prior to assembling the Printer  

2. 

Insert the Heated Print Bed Controller carefully through the legs of the 

Extruder Tower and align the bolt holes on each side. Using the Hex 

Wrench, insert and tighten the two bolts on bottom of each Extruder 

Tower 

3. 

Insert the long cable connector marked A into the motor connector of 

the Extruder Tower marked A 

4. 

Insert the short cable connector marked B into the motor connector 

of the Extruder Tower marked B 

5. 

Insert the white connector marked C into the motor connector of the 

Extruder Tower marked C 

SETUP