Bambi MD150/500 Operator's Handbook Manual - page 8

Summary of MD150/500

  • Page 1

    Bambi air compressors ltd 152 thimble mill lane heartlands birmingham b7 5ht united kingdom tel: 0121 322 2299 fax: 0121 322 2297 email: sales@bambi-air.Co.Uk www.Bambi-air.Co.Uk md r a n g e o p e r a t o r s h a n d b o o k covering models:- md35/20 md75/80 md75/150 md75/150v md75/250 md75/250v md...

  • Page 2: Operating Manual

    Operating manual your bambi air compressor is a precision engineered product. By following these simple steps you will ensure years of trouble free use. Parts & service are available from your bambi dealer. It is important to quote model, type & serial number in all communications. The substitution ...

  • Page 3: Safety Precautions

    1 safety precautions what you must do read these instructions before using your air compressor. Ensure the compressor has been installed, electrically connected and piped in by a properly qualified person. Ensure the compressor is kept upright at all times. What you must not do do not attempt any ma...

  • Page 4: Operation

    2 operation refer to exploded parts diagrams and illustrations when reading this section. Oil level your bambi compressor is shipped without oil for transit. Before use you must fill the motor to the correct level. Model 35/20 remove oil filler plug - see fig 1 pour oil into motor until correct leve...

  • Page 5: Routine Maintenance

    3 routine maintenance draining the air receiver drain condensate from air receiver at a pressure of no more than 2 bar. Slowly open the drain tap provided to allow water to flow out – see figs 7 & 8. Close drain tap when all water has drained off. Do not overtighten, this will damage the tap seal. A...

  • Page 6: Preventative Maintenance

    4 preventative maintenance operation daily weekly monthly annually drain air receiver • drain air receiver > 15 litres • drain filter regulator • check oil level • change oil • replace air intake filter • replace filter regulator element • check pressure relief activation • above are to be considere...

  • Page 7: Wiring Diagram

    5 capacitor overload protector to pressure switch start relay black brown black blue black wiring diagram 75 pump unit wiring diagram 35 pump unit.

  • Page 8

    6 md35/20 ref no. Description part no. 1 4 litre vessel bpb1094 2 filter regulator bpb1080 3 regulator gauge bpb1077 4 1/4” male/female elbow bpb1139 5 on/off valve bpb1079 6 1/4” male/female/female tee bpb1109 7 1/4” male / 1/4” male adaptor bpb1078 8 vessel pressure gauge bpb1081 9 200mm delivery ...

  • Page 9

    7 1 3 5 6 7 8 9 10 11 13 12 14 15 16 17 18 2 4 ref no. Description part no. 1 8 litre vessel bpb1100 2 black round tube insert bpb0076 3 235mm nylon syphon tube bpb0028 4 inspection plug seal bpb0502 5 inspection plug bpb0255 6 drain tap bpb1138 7 250mm drain tube bpb0414 8 pressure switch bpb1074 9...

  • Page 10

    1 3 5 6 7 8 9 10 11 13 12 14 15 16 17 18 19 2 4 8 md75/150 ref no. Description part no. 1 15 litre vessel bpb1099b 2 140mm wheel bpb1144 3 starlock washer bpb1091 4 inspection plug bpb0243 5 inspection plug seal bpb0502 6 1/4” male/female/female tee bpb1109 7 non-return valve bpb1086 8 200mm deliver...

  • Page 11

    9 ref no. Description part no. 1 15 litre vessel bpb1099 2 non-return valve bpb1086 3 500mm delivery pipe bpb1087a 4 pressure switch bpb1074 5 1/4” 10 bar relief valve bpb1084 6 1/4”male / 1/4”male adaptor bpb1078 7 1/4” male/female elbow bpb1139 8 filter regulator bpb1080 9 regulator gauge bpb1077 ...

  • Page 12

    10 1 3 5 7 8 9 10 11 13 12 14 15 16 17 18 19 4 6 2 md75/250 ref no. Description part no. 1 24 litre vessel bpb1088b 2 inspection plug seal bpb0502 3 inspection plug bpb0243 4 200mm delivery pipe bpb1102 5 non-return valve bpb1086 6 1/4” 10 bar relief valve bpb1084 7 1/4” male/female/female tee bpb11...

  • Page 13

    11 1 3 5 7 8 9 10 11 13 12 14 15 16 17 4 6 2 md 75/250v ref no. Description part no. 1 24 litre vessel bpb1088 2 non-return valve bpb1086 3 500mm delivery pipe bpb1087a 4 pressure switch bpb1074 5 1/4” 10 bar relief valve bpb1084 6 1/4” male / 1/4” male adaptor bpb1078 7 1/4” male/female elbow bpb11...

  • Page 14

    12 1 3 5 6 7 8 9 10 11 13 12 14 15 16 2 4 21 22 17 18 19 20 md150/500 ref no. Description part no. 1 50 litre vessel bpb1097 2 inspection plug bpb0243 3 inspection plug seal bpb0502 4 300mm delivery pipe bpb1087 5 1/4” male/female/male tee bpb0158 6 200mm delivery pipe bpb1102 7 1/4” male/female/fem...

  • Page 15

    13 1 3 5 6 7 8 9 10 11 13 12 14 15 16 23 24 2 4 21 22 17 18 19 20 md225/1000 ref no. Description part no. 1 100 litre vessel bpb1105 2 inspection plug bpb0243 3 inspection plug seal bpb0502 4 300mm delivery pipe bpb1087 5 1/4” male/male/female tee bpb1095 6 300mm delivery pipe bpb1087 7 1/4” male/ma...

  • Page 16

    14 37 2 3 4 5 6 7 8 9 10 11 14 15 16 17 18 19 20 21 23 24 26 27 28 30 31 33 34 35 36 40 13 12 29 39 38 32 25 1 22 41 42 7 motor / pump parts: 75 model ref no. Description part no. 1 mounting set bpb1008 2 bottom casing bpb1011 3 large rubber gasket bpb1007 4 closing ring bpb1005 5 bearing bolt bpb10...

  • Page 17

    15 motor / pump parts: 35 model 21 23 24 26 27 28 30 31 29 32 25 2 3 4 5 6 7 8 9 10 11 14 15 16 17 18 19 20 13 12 1 22 ref no. Description part no. 1 oil filler plug bpb0079 2 oil filler plug seal bpb0098 3 top casing bpb1058 4 closing ring bpb1059 5 sealing gasket bpb1057 6 air intake filter bpb100...

  • Page 18

    On off fig 1 fig 3 fig 4 fig 5 + _ 16 “click” fig 2 sb 4 2/46 a.

  • Page 19

    Fig 6 17 fig 6 fig 8 fig 9 fig 7 “click” sb 42/4 6.

  • Page 20

    Issue 1: 11/06.