Summary of tracker
Page 1
Owner’s manual h0532000 rev a.
Page 2: Important Information
Page 2 important information notice for vinyl liner pools: before installing your pool cleaner, examine the interior of your pool carefully. If the vinyl liner is brittle or has stones, wrinkles, roots or metal corrosion in contact with the underside of the liner, or has damage to the base material ...
Page 3: Introduction
Page 3 introduction congratulations on the purchase of your new baracuda ® tracker ™ automatic pool cleaner. Your tracker is designed and manufactured for easy installation, and years of carefree operation. Before installing the cleaner, please take a few moments to become familiar with its componen...
Page 4: Installation
Page 4 1. Before you start for best cleaner performance, you will need to follow the following steps of the installation. 1.1 following manufacturer’s instructions, clean the filter and empty the skimmer and the pump strainer basket. 1.2 if your main drain is connected to the skimmer box, block off ...
Page 5: Installation
Page 5 installation 4th case: with any other type of skimmer box and vac plate simply insert the ad flow valve directly into the universal weir cuff which will then fit into the top of the vac plate. Note: the ad flow valve has three settings: high (3), medium (2) and low (1). To deliver the maximum...
Page 6: Installation
Page 6 4. Connecting cleaner head to flow regulator valve 4.1 remove orange sticker off leader hose. 4.2 attach the flow regulator valve to the leader hose and connect the cleaner head to the flow regulator valve. 5. Re-connecting to skimmer box 5.1 temporarily disconnect hose from skimmer, turn on ...
Page 7: Care And Maintenance
Page 7 care and maintenance the tracker ™ pool cleaner cycles on/off with the pool filtration pump, vacuuming and cleaning all surfaces randomly throughout the pool. The climbing ability of the cleaner is dependent on the pool’s shape and available water flow. If your tracker is not climbing the poo...
Page 8: Warning
Page 8 removing debris from the engine warning to avoid serious injury, make sure that the cleaner is disconnected from the hose and the pool suction pump is turned off prior to starting this operation. 1. Push the latch release button on the top of the cleaner. 2. Rotate the top lid assembly back u...
Page 9: Troubleshooting
Page 9 if you experience a problem with your tracker ™ , please follow the troubleshooting steps below to restore performance. If further assistance is required, contact baracuda ® after sales support department at 1300 784 423. Please have your serial number and date of purchase available when you ...
Page 10
H0532000 rev a baracuda is a registered trademark of zodiac group australia pty ltd abn 87 002 641 965 219 woodpark rd, smithfield, nsw 2164 australia tel: 1800 688 552 www.Zodiac.Com.Au © copyright zodiac australia ltd 2015.