Barcus-Berry Breeze IV Installation Manual
9. Installtheoutputjackassemblyto
the guitar using four of the wood
screwssuppliedandasshowinthe
illustrationbelow.
10.Route the wire toward the preamp
opening using the supplied cable
clips to secure the cable inside
thebody.
11. Likewise route the pickup cable
towardthepreampopening.
12.Install a battery into the preamp
(seeowner
’smanual)andverifythe
operationoftheunit.
CONNECT OUTPUT
JACK HERE
INSERT SADDLE
PICKUP JACK
HERE
MIC OR
CONTACT PICKUP
13.InserttheBreezethroughthepreamp
opening into the guitar to allow
cableconnectionstobemade.
14.Firmly holding down the preamp
assembly in opening, Insert the
under-saddle pickup cable into
thepreamp
’s2.5mmjackasshown
intheillustration.
15.Inthesamefashion,inserttheoutput
connector into the 5-pin molex
connector.InthecaseoftheBreeze
II, the mating connector has only
threepins.Matethisconnectorto
themiddlethreepinsoftheoutput
connector.Thiswillleaveoneopen
pinoneithersideofthejack.
16.IfinstallingaBreezeIVsystemwith
an auxiliary pickup, at this time
install the cable from this pickup
into the 3.5mm AUX jack, located
nearthesaddlepickupinput.
17.Beforeattachingthetrimplateand
preamp to the body of the guitar,
Confirmoperationofthepreampby
plugging the guitar into an amp
orPAandtestingallfunctions.
18.Finally,
referring
to
the
illustration above, align the
preampmountingtabstothepilot
holesandusethefourwoodscrews
provided to attach the preamp.
Insertthewoodscrewsthroughthe
preamp trim plate, mounting tabs,
and finally into the pilot holes.
Tightenuntilsnug.Thetrimplate
willflextoadapttothecurveof
theguitar
’supperbout.
Notes:
InstallationGuide
Barcus-Berry
®
POBox63366,NCharleston,SC29419USA
www.barcusberry.com
InstallationGuide
Barcus-Berry
®
POBox
63366,
N
Charleston,
SC
29419
USA
www.barcusberry.com
Breeze Installation.indd 1
12/3/2009 11:35:18 AM