C & K Systems Securit 700L User Manual - page 3

Summary of Securit 700L

  • Page 1

    This manual is from http://groups.Msn.Com/uksecuritypanels technical manuals online! - http://www.Tech-man.Com.

  • Page 2

    This manual will give you all the information you need to operate and control the securit 700l control panel. This manual will not tell you how to program or configure the control panel, for that see the engineering instructions. 1.0 setting 1.1 full set ( used when leaving premises ) to start the e...

  • Page 3

    Http://groups.Msn.Com/uksecuritypanels rejected. You must then re-enter the "*" if needed. If option 7 5 has been enabled by your installer you can also manually isolate the entry exit zone in part set. 2.0 unsetting ( used to dis-arm the control panel ) enter by the specified route, the buzzer will...

  • Page 4

    4.0 user options 4.1 changing zones on chime "chime" is a facility to make particular zones chime when triggered. For example, you could have a front door chime when opened or a room with valuables in chime when entered. Chime is only active when the panel is unset. To configure any zones to chime y...

  • Page 5

    If your new code is allowed an accept tone will be given. If the new code is barred an error tone will be given and your old code will still be valid. Start again and enter a different four digit code. To remove or disable a second user code enter the four digit user code, the buzzer will emit a ste...

  • Page 6

    Time start. Press the * key followed by the 9 key, then press the 4 key. The buzzerwill emit a low level steady tone. As you test each device the internal sounder will give a loud pulsing tone to indicate the correct operation of that device. The zone number led will light. When the device tested cl...