© c security systems ab 2012 installation manual.
3 contents installation manual – p. 4 1. Creating the user account 2. Installing the system 3. System start up 4. Finishing the setup 5. Configuring system user guide – p. 15 • system mode • alarms • warnings • activate and deactivate alarms • triggered alarms • triggered warnings reference manual –...
4 installation manual 1. Creating the user account create your personal web portal account on www.Mycpod.Com by sending the registration text message, logging in and completing the setup wizard. A. Send registration text (sms) message send a text (sms) message contain- ing the activation code of you...
5 note: the password must contain at least 7 characters and 1 number. Don’t choose a guessable password! B. Login & complete wizard use the temporary login data you just received to log on to www.Mycpod.Com , where you are guided through an installation wizard. Complete the steps until the wizard te...
6 a. Check package contents included in the box: – c-pod main unit – fastener for the main unit – gps antenna – cellular (gsm) network antenna – magnetic intrusion sensor – power cable – activation button – hook-and-loop fastener for the gps antenna – manual – warranty sheet in addition to this, you...
7 installation manual 2. Installing the system (continued) b. Find a suitable onboard location for the c-pod the c-pod should be installed in a well hidden and dry place onboard. Other factors that must be considered are cellular (gsm) network and gps signal reception, access to constant power suppl...
8 installation manual 2. Installing the system (continued) the gsm antenna screws on to the contact marked gsm on the c-pod unit. The gps antenna has a 3 meter cord that attaches to the contact marked gps on the unit. The antenna must be placed horizontally with the plastic dome facing upwards . Fin...
9 the activation button should be dis- creetly located inside the area pro- tected by the magnetic intrusion sen- sor, so that it can be reached within 45 seconds of entering the boat to deactivate the alarms. The button has a led indicator in the center which must be visible. Connect the button to ...
10 installation manual 2. Installing the system (continued) note: fuse and fuse holder are not included in the package. Note: before proceeding, it is recommended to measure and verify the received voltage on the power plug using a voltmeter! Note: some optional accessories cannot be used if the c-p...
11 installation manual 3. System start-up connect the power plug to the pow- er port marked with on the c-pod. The c-pod starts up. Pay attention to the flashing of the activation button, which shows the start-up progress. • the activation button flashes once every second until the c-pod has connect...
12 installation manual 4. Finishing the setup once the installation in the boat is completed, log on to the web portal with your personal user name and the password you chose in the installation wiz- ard. A. Verify cellular (gsm) network/gps position verify that the c-pod has a working communication...
13 installation manual 5. Configuring the system before starting to use the system to full extent, some settings need to be con- figured. Navigate by clicking on the menu items to the left. A. Action plan the action plan defines which text (sms) and/or e-mail messages are sent to which recipient(s) ...
14 installation manual 5. Configuring the system (continued) d. Communication warning the communication warning is turned off by default. It monitors the gprs data traffic, which requires a sufficient cellular (gsm) network signal quality. If the cellular (gsm) network is strong at the location of y...
Www.C-pod.Com p1703-161 v .2.