Cht 400 hydraulic tool 35 - 400 mm² hydraulic crimping tool instruction manual.
1 crimping range: for standard copper terminal for din 46235 copper terminal for din 48201 aluminum terminal in 30 type die no die no cord no female die 凹 female die 凸 b3010 cu10 d3010 cu10 al6 k6 if3010 cu10 im3010 10-25 b3016 cu16 d3016 cu16 al10 k8 if3016 cu16 im3035 35-50 b3025 cu25 d3025 cu25 a...
2 caution： l when die is not installed in the tool, please do not operate the tool to avoid damaging the tool. L please check the ram whether in place or not after using. Avoiding inner spring tired and cannot return. L this tool is non-insulated. Please turn off the power while working and wear ...
3 instruction a. Inset the suitable die as below pictures. ●attention: inset suitable die (please consult p.2) inset die： figure 1. Inset / take out die hydraulic crimping tool instruction manual.
4 b. Inset the die in place, then start pressing. Meanwhile, the die will go forth/ go back for pressing. Please see figure 2, 3, and 4. ●attention: ● while pressing, please release the oil as hear sound “bo”. Figure 2. Go forth –pressing figure 3.Twist the movable handle figure 4.Go back-return oil...
5 maintenance & eliminate breakdown： (1) maintenance q & a： 1. Q：exchange oil or add oil. A：please exchange oil to keep the oil quality that can be prolong its usage age and working well. This tool accepts shell tellus t-15 hydraulic oil only. Please do not mix other ingredient oil to avoid any brea...
6 (2 ) eliminate breakdown q & a： 1. Q：how to add oil in the inside of tool when the oil is not full enough? A：what was the cause of shortage of oil inside? It causes the oil evaporated by using for a long period. It causes leak oil by improper uses or moving. Condition : please return the tool to s...
