1. DL manuals
  2. Cam
  3. Analytical Instruments
  4. SenseLife
  5. User Manual

Cam SenseLife User Manual

Manual is about: Indoor Air quality Monitor

Summary of SenseLife

  • Page 1

    Senselife cam indoor air quality monitor user manual sections: part 1. Usb driver installation part 2. Program installation part 3. Set time and date do not plug the cam into your pc before installing the usb drivers or it will not work properly. If you have already plugged the cam in, you must unpl...

  • Page 2

    2 part 1.Usb driver installation 1. Go to www.Co2meter.Com/products/cam-co2-meter-powered-by-auto-home-or-usb 2. Save the file “usb drivers (zip)” to your desktop. 3. Unzip the file and run the program cp210_win2k_xp_s2k3.Exe. Follow the on-screen instructions: click “next” 1. Click 2. Click “next”.

  • Page 3

    3 click “next” click “install”.

  • Page 4

    4 4. Connect the cam to your computer by usb cable. You will see a pop-up window similar to the one below (window can be different depending on your operating system). Be patient! It may take a few minutes until the wizard finishes searching. If the wizard is unable to find the driver, hit the “ bec...

  • Page 5

    5 5. To test for proper installation, click “start” Æ “control panel” Æ “system” on your computer click “finish”.

  • Page 6

    6 6. Click “hardware” Æ “device manager” 7. Click port (com & lpt) 8. If you can see usb to uart comxx the driver is successfully installed. If you cannot see it, go to the “control panel” again and execute “add new hardware” function. 9. The comxx port will vary according to each pc’s usb port. Wri...

  • Page 7

    7 part 2. Program installation 1. Save the “program file (zip)” named cp210_run.Zip to your desktop. Create a new folder, and unzip all the files into the new folder. 2. Double-click “co2_monitor.Exe” in the folder to run the program. 3. Select the com port to the setting you wrote down previously. ...

  • Page 8

    8 5. Click connect button 6. Co2 concentration being displayed on cam can be monitored. If the co2 level in ppm does not respond, it is either because the wrong com port number was selected in “settings” or the usb driver was not properly installed. Try selecting each of the different com ports unde...

  • Page 9

    9 part 3. Settings 1. Set the time [1]pressing “mode” at least 2 seconds, “year” section flickers [2]set “year” by “up/down” [3]pressing “mode” once, “month” section flickers. Set “month” by “up/down” [4] pressing “mode” once, “date” section flickers. Set “date” by “up/down” [5] pressing “mode” once...

  • Page 10

    10 while time setting mode, you can finish setting by pressing “mode” more than 2 seconds 2. Backlight on/off [1]pressing “down” more than 2 seconds, backlight will be off. In the light if off, by pressing “down” more than 2 seconds, backlight will be on.