Camec Elite Pro2 EM305 User Manual

Manual is about: Caravan Mover

Summary of Elite Pro2 EM305

  • Page 1

    Elite pro ® 2 caravan mover user manual model: camec elite pro ® 2 em305 part no: 043322 for professional installation only.

  • Page 2

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 2 package contents (parts list) page 3 introduction page 4 intended use page 4 specifications page4 installation - safety guidelines page 5 installation - mechanical components page 6 installation - electrical/electronic components page 8 i...

  • Page 3

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 3 package contents.

  • Page 4

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 4 introduction intended use specifications congratulations on choosing the camec elite pro ® 2 em305 caravan manoeuvring system. This has been produced according to very high standards and has undergone careful quality control procedures. B...

  • Page 5

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 5 installation - safety guidelines read this user manual carefully before installation and use. Failure to comply with these rules could result in serious injury or damage to property. These symbols identify important safety precautions. Th...

  • Page 6

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 6 for professional installation only. These instructions are for general guidance. Installation procedures may vary depending on caravan type. Working under a vehicle without appropriate support is extremely dangerous! • place the caravan o...

  • Page 7

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 7 • make sure that the main cross bar (3) is positioned in the middle of the caravan (the centre of the bar is marked). • whenthemainassemblyislooselyfitted onto the chassis, slide the whole assembly along the chassis until the rollers are ...

  • Page 8

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 8 installation - electrical/electronic components make sure the 12v supply from the battery and any 240v electricity supply are disconnected. • remove battery cable terminals and disconnect any external electrical power before starting work...

  • Page 9

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 9 • mark the motor cables for both motor units using the cable markers (25). The cables for the left and the right motor should have the same length. Avoid any loops. Remember to leave a small amount of slack cable near the motors to allow ...

  • Page 10

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 10 installation - twin axle when you use the manoeuvring system for a twin axle caravan, please check the following: permissible overall weight twin axle (2 motors) 2000kg (1750kg on 18% gradient) permissible overall weight twin axle (4 mot...

  • Page 11

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 11.

  • Page 12

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 12 operation - safety guidelines practiceoperatingthemanoeuvringsysteminanopenareabeforeusingforthefirsttimetofullyfamiliariseyourself with the handset and manoeuvring system operation. Before use, always check the caravan manoeuvring syste...

  • Page 13

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 13 operation - motor units the manoeuvring system has two motor units (1 & 2). In general they are mounted in front of the axle of the caravan. Both units are identical but cannot be switched. A. Aluminium drive roller b. Drive unit, includ...

  • Page 14

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 14 operation - remote control handset the remote control handset (5) is powered by one pp3 9 volt battery, and is activated by moving the slide switch to “on”-i (fig. 14a). Once activated, the green led (fig. 14h) will illuminate and the di...

  • Page 15

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 15 when the remote handset is in “stand-by” mode, it may still draw some current. Be sure to slide the switch to “off” –o to preserve the battery. To reactivate the remote control, move the slide switch to “off” –o and then back to “on” –i ...

  • Page 16

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 16 operation - electronic control unit the electronic control unit (4), which is mounted inside your caravan, is responsible for controlling the manoeuvring system. The control unit has three led’s, one push button and one slide switch (fig...

  • Page 17

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 17 operation - getting started please make sure you read the safety instructions very carefully and follow these guidelines! Make sure that the battery that supplies the system is fully charged and in good condition. Make sure that the cara...

  • Page 18

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 18 operation - hitching and unhitching maintenance troubleshooting it is possible to position the caravan’s hitch exactly over a stationery car’s tow ball using the manoeuvring system. But please be very careful! Use the button controls on ...

  • Page 19

    Camec elite pro ® 2 em305 ref: elite pro 2 em305-0715rev.A. 19 • check the battery of the remote control handset. If empty, renew the 9v battery. • caravan battery could be empty. If empty, recharge completely or renew caravan battery before taking any further action. • caravan battery could be over...

  • Page 20

    Contact information australia new zealand 47-63 remington drive airport business centre dandenong south 3175 44 montgomerie road, mangere phone: 1300 4 camec (22632) phone: 0011 64 9 257 2419 www.Camec.Com.