Camry EK-9 Series Instructions For Use
05EK-016E R1
g
1.
2.
7
6
EK-9 SERIES
1. When setting time span, touch "T-SET" to confirm and prompt to next digit. After
setting time span, touch "T-SET" to start counting down. During counting down,
touch "T-SET" to clear the set time span.
2. The timer counts down to "00:00", alarm will start "beeping" for 60 times and
switch off automatically
3. Touch any key to stop "beeping".
4. Max. time span of the alarm timer: 99:59.
scale
will
TO SET ALARM TIMER
WARNING INDICATORS
1. Replace new battery.
2. Scale overload. Remove item to avoid damage.
Max.Weight capacity is indicated on the scale.
CLEANING AND CARE
1. Clean the scale with a slightly damp cloth. DO NOT immerse the scale in water
or use chemical/abrasive cleaning agents.
2. All plastic parts should be cleaned immediately after contact with fats, spices,
vinegar and strongly flavored/colored foods. Avoid contact with acids citrus juices.
3. Always use the scale on a hard, flat surface. DO NOT use on carpet.
TEMPERATURE SENSOR
o
1. Temperature range: 0~+40 C
o
2. Division: 0.5 C
Condition 2: "TARE" function
When LCD reading is >1g,
LCD will show “-----” or “0g” each time “
is touched.
“-----” means not stable, please wait for a moment. “0g”
and meanwhile an icon “TARE” on upper left corner of
LCD mean “TARE” function is active. Max. capacity is
reduced by total weight of all loads.
Z/T”
Electronic Kitchen Scale with Touch Button
INSTRUCTIONS FOR USE
Temperature
display
Auto shut-off occurs if display shows
'0' or shows the same weight reading
for 2 minutes.
AUTO SHUT OFF
MANUAL SHUT OFF
To maximize battery life,
"ON/OFF" again to turn off the scale
after using.
always touch
Touch "ON/OFF"
to switch on
Touch "T-SET"
to
start
count
down
Touch
"T-SET”
Touch
"T-SET”
Touch T-SET
to begin a l a r m
t i m e r s e t t i n g
"
"
Touch
"T-SET”
Setting
1st binary digit
for
minutes
Setting
2nd binary digit
for
minutes
Setting
1st binary digit
for
seconds
Setting
2nd binary digit
for
seconds
ISO 9001:2000 CERTIFIED BY SGS
5