Dacor Epicure OF24 Planning Manual
PLANNING
GUIDE
Web: http://www.Dacor.com
Corporate Phone: 800-793-0093
Specifications are subject to change without notice.
See installation instructions for additional details.
11.2
24” Outdoor Refrigerator
OF24LS, OF24RS
23 1/8”
587mm
34 1/4”
M
in.
870mm
24” M
in.
610mm
45” Max.
1143mm
597mm
23 1/2”
70” Max.
1778mm
24”
610mm
34”
M
in.
864mm
*
Dedicated Circuit Required
Total Connected Load
120 Vac, 60 Hz, 15 Amp.
(Breaker)
0.1 kW (1.2 Amp.)
Operating Environment
Do not operate this appliance near an oven, range top,
◊
radiator or similar heat source. For best performance,
do not place this appliance where it will be hit by direct
sunlight or exposed to extreme weather conditions.
This appliance is designed to operate outdoors. It is set
◊
to operate within the ambient temperature limits listed
below. These temperature limits should not be exceeded.
AmbiEnT TEmpERATuRE REquiREmEnTs
fOR pROpER OpERATiOn
50°F to 109°F (11°C to 42°C)
Enclosed Cabinet or under-Counter-Top
Layout Requirements
The Dacor outdoor refrigerator can be recessed within an
opening between cabinets or placed under a counter-top if
desired.
impORTAnT:
The installation
◊
location should permit the door to open a
minimum of 90°. The maximum angle the door can open
is 105°.
The appliance must be l
◊
ocated so that the grill on the
bottom is not obstructed.
The electrical outlet must be accessible after installation
◊
so that the user can unplug the appliance.
T
◊
he floor under the appliance must be flat and level with
the surrounding floor.
If installing the unit in a cutout, make a hole in the side of
◊
the cutout to allow the power cord to pass through to the
electrical outlet.
1/1
CAbINEt CUtOUt/COUNtER-tOP AND
PRODUCt DImENSIONS
nOTE:
1.
The overall height of the appliance can be increased by
½” (12.7 mm) by adjusting the feet. The minimum cutout
dimensions above allow for additional clearance for sliding
the appliance into a recess based on how you choose the
final installation to look.
Revised
04/15/08
*Depth excluding handle depth of 2 1/2” (64mm)