E-bikes A1 Owner's Manual - page 8
8
www.e-bikes.se
Front Brake Set Up
V-Type brake. Clip Cable Guide through black support holder
as shown. Loosen the 5 mm Allen key cable holder and pull
cable through until the pads are just touching the rim. Ensure
you have removed the rubber band from the lever. Adjust as
necessary so brake shoes are square with wheel surface and
are not rubbing on wheel during rotation. Around 1-2 mm
clearance is ideal
.
Gear adjustments: normally a gear instruction will be supplied with the bike.
• It is recommended you have a bicycle workshop assist you with the adjustment of the gears.
•Cable tension must be checked to ensure there is no slack in cable when in highest (fastest gear). Failure to do
this will result in poor gear changes.
•Tension of cable can be adjusted on the rear of the cable insertion point on the back of the derailleur.
•Lube chain and sprockets regularly with a Teflon based chain lube.
Inflate Tyres to 65 PSI and maintain ongoing by checking once per week. Correct tyre pressure is critical to the
performance of the bike
.