E Star A18 User Manual - Getting Started

5

GettInG Started

Please switch off your device before inserting or removing the battery /SIM 

card or memory card.

3.1. InStallInG SIm card and Battery

Your device is provided with two SIM slots for two different SIM cards. The 

SIM card inserted in the slot1 is called Master SIM, and the other one in the 

slot2 is known as Slave SIM.

Remove the back cover of the device.

Hold the phone with the front facing downwards; pull the cover.

Insert the SIM cards and battery in the device.

Attach the battery.

Push the battery cover until it clicks into place.

3.2. InStallInG memory card

Your device supports T-Flash card, which is a multimedia memory card used 

to multiply the memory of the device. The T-flash card is small and should 

be pulled out and installed carefully and prudently in order to avoid any 

kind of damage. 

• Switch off your device.

• Remove the battery cover. 

• Slide the T-Flash card into the slot.

• Attach the battery.

• Push the battery cover until it clicks into place.

3.3. charGInG the Battery 

The device prompts a warning tone and message stating insufficient battery 

when the battery power of your device is low.  

Please follow the instructions mentioned below to charge your device:

• Plug the connector of the charger into the jack of the device. 

• Plug the charger into a standard AC wall outlet.

note: When power charging is shown on the screen, it indicates that there is 

not enough power and you should now charge your device. When charging 

is complete, the battery icon will stop flashing. You must fully charge the 

battery before using the device for the first time. It is recommended to 

charge the battery for four hours before using the device for the first time. If 

the device is turned on during charging, you can still make or answer calls, 

but this will consume battery power, thus will extend the charging time of 

the device.