Echoflex MOS-17 Installation Manual

Summary of MOS-17

  • Page 1

    Mos-17 echo flex motion-occupancy sensor installation guide product overview this guide covers mos-17 models which are equipped with enocean 315 mhz radios. Models include: mos-17ca with small motion lens - 1000 sq.Ft. Range, mos-17cb with large motion lens - 1900 sq. Ft. Range and the mos17-cc for ...

  • Page 2: Pir Motion Detection

    2 pir motion detection the pir sensor is an optical sensor that detects motion by measuring the infrared heat given off by objects. The sensor is calibrated to detect the heat range of human body temperature. The sensor has a lens that breaks the viewing angle of the sensor into zones that focus the...

  • Page 3: Sensor Location

    3 sensor location there are three primary objectives when finding a suitable location for the sensor. 1. Placing the sensor for proper occupancy detection. 2. Placing the sensor so the receiver in within radio range. 3. Placing the sensor so it can harvest adequate light energy. Occupancy detection ...

  • Page 4: Range Planning

    4 range planning on floor-plan drawings, draw 100 feet (30m) diameter circles around the location of each controller to identify optimal transmitter locations. Refer to the table below for range considerations with building materials that reduce the radio signal power. Use an epm300c for on-site ran...

  • Page 5: Sensitivity Setting

    5 sensitivity setting the mos sensor has a slide switch that the user can use to select max. Or min. Sensitivity levels. False occupancy states caused by other elements can be reduced by selecting the min. Sensitivity level. The default setting is max sensitivity. To change the sensitivity setting: ...

  • Page 6: Layout Hints

    6 layout hints • avoid transmitting down a length of wall to reduce signal reflection. • avoid transmissions that must penetrate walls at acute angles. This increases the wall material the telegram must pass through, greatly reducing the signal power. • avoid large obstructions. Place receivers in a...

  • Page 7: Equipment Profiles

    7 equipment profiles eep: a5-07-01 occupancy sensor - pir on, pir off technical specifications power supply operational light level charging period initial operation solar cell, optional battery (cr2032) backup,operational light level 30 lux (3 foot candles) minimum initial operation 6 hours full ch...

  • Page 8: Listings and Compliance

    8 listings and compliance fcc part 15.231 contains fcc id: xmg-stm112c the enclosed device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (i.) this device may not cause harmful interference and (ii.) this device must accept any interference received, in...