Edelbrock 1465 Installation Instructions

®

Off-Road Needle & Seat Assembly

for Performer Series Carburetors

Catalog # 1465

Installation Instructions

)

Please study these instructions carefully before installing your Off-Road needle & seat assembly. If you have any

questions or problems, do not hesitate to contact our Technical Hotline at: (800) 416-8628 from 7:00 am to 5:00

pm, Monday through Friday, Pacific Standard Time or e-mail us at: edelbrock@edelbrock.com.

)

Use Owner's Manual supplied with carburetor for disassembly and reassembly.

)

Remove original needle and seat assembly and replace with #1465 (Figure 1). To reset float level, see Figure 2 for proper

offroad setting (7/16").

OFF-ROAD FLOAT LEVEL

With bowl cover inverted, bowl cover gasket in place, and

weight of float seating needle, there should be 7/16" between

top of each float and bowl cover gasket (at outer end). The

sides of floats should be parallel to the outer edge of the bowl

cover. To adjust, bend float lever.

CAUTION! DO NOT PRESS NEEDLE INTO SEAT WHEN

ADJUSTING FLOAT LEVEL.

Brochure #63-0162

© 2002 Edelbrock Corporation

Rev. 12/02

Needle and Seat assembly

BEND HERE

MEASURE AT

OUTSIDE END

7/16"

Figure 1

Figure 2