Edelbrock 15005 Installation Instructions

©2004 Edelbrock Corporation

Rev. 1/04 - RS/mc

Catalog #15005

Brochure #63-0245

INTAKE MANIFOLD GASKET

(For Honda D16Y8 Engines)

Catalog #15005

INSTALLATION INSTRUCTIONS

®

PLEASE study these instructions carefully before installing your new Edelbrock Intake Manifold Gasket. If you have any

questions or problems, do not hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-

Friday, Pacific Standard Time or via e-mail at: Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.

Installation Procedure

KIT CONTENTS

Qty.

Description

1

Intake Manifold Gasket

• Description: This is a replacement intake manifold gasket, which is supplied in the catalog #1500 turbo kit, as well as

the intake manifold kits, #4754 & #4756.

Edelbrock Corporation

2700 California St.

Torrance, CA  90503

Tech Line: 1-800-416-8628

Office: (310) 781-2222

E-Mail: Edelbrock@Edelbrock.com

1. Remove the intake manifold as shown in your instructions for part #1500, #4754, or #4756.

2. Clean all gasket mating surfaces. Stuff paper towels into the open intake ports before cleaning to prevent any debris from

entering the engine.

3. Re-install the intake manifold as shown in the #1500 or #4756 instructions, using the new gasket. If your vehicle was not

equipped with air injection, trim the top edge of the gasket 

(See. Fig. 1)

.

4. Torque all intake manifold bolts to 17 ft/lbs., following the sequence below 

(See Fig. 2)

.

1

7

4

3

5

2

Torque all bolts to 17 ft./lbs

6

Fig. 2

Fig. 1

Cut along dashed lines