Edelbrock 15018 Installation Instructions

©2004 Edelbrock Corporation

Brochure #63-0344, Rev. 3/05

Catalog #15018

REPLACEMENT O-RING KIT

For Oil Supply Adapter #15010

Catalog #15018

INSTALLATION INSTRUCTIONS

®

PLEASE study these instructions carefully before installing your new Edelbrock Oil Supply Adapter. If you have any questions or problems, do not

hesitate to contact our Technical Hotline at: 1-800-416-8628, from 7am-5pm, Monday-Friday, Pacific Standard Time or via e-mail at:

Edelbrock@Edelbrock.com. Please fill out and mail your warranty card.

•

DESCRIPTION:

This kit includes three (3) replacement o-rings for oil supply adapter #15010 (Adapter #15010 is also used in Edelbrock Turbo Kits #1500,

1501, 1502, 1503, & 1504).

•

KIT CONTENTS:

1 - Oil Adapter to Engine Block O-Ring

1 - Insert to Adapter Housing O-Ring

1 - Supply Fitting to Adapter Housing O-Ring

Installation Procedure

Edelbrock Corporation • 2700 California St. • Torrance, CA  90503

Tech Line: 1-800-416-8628 • E-Mail: Edelbrock@Edelbrock.com

1.

Disconnect your supply line from the adapter, remove oil filter (replace), and remove Oil Supply Sandwich Adapter using a 1/2” Allen wrench.

2.

Dissasemble the adapter and replace o-rings (See Figure 1).

3.

When reinstalling the adapter, make sure the adapter to engine block o-ring is facing toward the engine block, and the threaded stud with ½”

hex opening is facing out.

4.

Tighten with a ½” Allen wrench. Make sure the blue fitting is facing toward the driver’s side, pointing upward slightly, about the 10 o’clock

position.

5.

Install a new oil filter.

6.

Reattach your supply line.

Replace O-Ring Under -6AN Fitting

Replace Large O-Ring On Engine

Block Side of Adapter

Towards Engine Block

Carefully Press Out the

Threaded Center of Supply

Adapter and Replace O-Ring

FIGURE 1 - Oil Supply Adapter