Edelbrock 1565 Installation Instructions
©2007 Edelbrock Corporation
Brochure #63-1565
Page 1 of 1
Edelbrock Snout Support and Pulley Kit
Rev. 11/07 - AJ/mc
®
EDELBROCK/BILLET SPECIALTIES TRU TRAC PULLEY SYSTEM
for use with Edelbrock Superchargers
Catalog #1565 & #1566
INSTALLATION INSTRUCTIONS
Please study these instructions carefully before installing your new Tru Trac Pulley System. If you have any questions or problems, do not
hesitate to contact our Technical Hotline at: (800) 416-8628 from 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time or e-
mail us at: Edelbrock@Edelbrock.com.
DESCRIPTION: The Edelbrock Tru Trac Pulley System is a complete front end accessory kit that is designed specifically for use with Edelbrock
Superchargers offered as part #15611, #15621, #15631, #15641, and the Edelbrock supercharged crate engine #46700. Kit #1565 includes a
power steering pump while kit #1566 does not. Please consult the Billet Specialties instructions included with this kit before beginning
installation.
Edelbrock Corporation • 2700 California St. • Torrance, CA 90503
Tech-Line: (800) 416-8628 • E-Mail: Edelbrock@Edelbrock.com
Figure 1
Figure 2
NOTE:
The Edelbrock/Billet Specialties Tru Trac Pulley System is
intended for use with Edelbrock Superchargers only. The use of these
parts in any other application is not recommended or supported. The
following instructions should be used in place of steps #10 & #11 of the
supercharger installation instructions.
1.
Assemble the snout support, bridge bracket, and idler pulleys.
Attach the snout support to the bracket using the supplied M8
x 1.25 x 16mm long bolts. Attach the idler pulleys to the
bracket using the supplied M10 x 1.0 x 45mm long bolts.
Tighten the idler pulley bolts, but do not fully tighten the snout
support bolts at this time
(See Figure 1).
2.
Install the Tru Trac Pulley System according to the
instructions provided by Billet Specialties using the hardware
supplied as specified. Refer to
Figure 2, and the
instructions supplied by Billet Specialties for the proper
bridge bracket installation procedure. Please note that the
bridge bracket in this kit has been modified to accomodate
the supercharger but the installation procedure remains
unchanged.
3.
Continue installing your Tru Trac Pulley System. When
finished, adjust the snout support so that it contacts the
supercharger snout, and tighten the snout support bolts.
INSTALLATION INSTRUCTIONS
Belt routing for Edelbrock/Billet Specialties Tru Trac Pulley System #1565
(w/ power steering pump)
NOTE:
For Kit
#1566 route
the belt as
pictured to
the left;
following
the white
dotted line.
IMPORTANT NOTE:
Proper installation is the responsibility of the installer. Improper installation will void warranty and may result in poor
performance and engine or vehicle damage.