Edelbrock 5262 Installation Instructions

©2007 Edelbrock Corporation

Catalog #5262

Brochure #63-0363

Rev. 8/07 - DA/mc

EDELBROCK PANHARD ROD

for 2000-2008 Suburban, Tahoe, Yukon, Denali, Escalade, Avalanche

and 2003-2008 Hummer HII

Catalog #5262

INSTALLATION INSTRUCTIONS

Please study these instructions carefully before installing your new Panhard Rod. If you have any questions, please contact

our  Technical Hotline at: 1-800-416-8628, 7:00 am to 5:00 pm, Monday through Friday, Pacific Standard Time or 

e-mail us at edelbrock@edelbrock.com. Please fill out and mail your warranty card.

Application: Designed for full size GM SUVs. This panhard rod is designed to stabilize the rear suspension.

Suggested Tools for Installation:

❑ Jack and proper load rated jackstands

❑ 18mm and 21mm combination wrenches

❑ 18mm and 21mm 1/2” drive sockets and ratchets

❑ Large screw driver

1.

Raise vehicle and support with jackstands on a stable surface.

Note: Vehicle must be supported with vehicle’s normal weight on rear axle.

2.

Remove the right lower sway bar end link nut.

3.

Unclip the cable attached to stock panhard rod, remove bolts at each end and remove the stock panhard rod from

vehicle.

4.

With zerk fitting pointing down, install the Edelbrock panhard rod in the stock position. Note: Edelbrock panhard

rod is greased during assembly, but we recommend you grease them after installation and during normal service.

5.

After you have greased the bushing through the zerk fittings, torque panhard rod bolts 85 to 90 ft. lbs.

6.

Re-install sway bar end link and nut. Torque to 40 ft. lbs.

7.

Use supplied stainless steel hose clamps to retain the brake cable to the Edelbrock panhard rod. Unscrew the

clamp completely. Wrap it around the panhard rod and the metal sections of the cable, re-engage the clamp and

snug clamp. Do not overtighten!

Kit Contents

Qty.

Part #

Description

1

25-4063

Panhard Rod Assembly

INSTALLATION INSTRUCTIONS

Edelbrock Corporation, 2700 California Street, Torrance, CA 90503

Toll-Free Tech Line: 1-800-416-8628

Office: 310-781-2222

Tech E-Mail: edelbrock@edelbrock.com

IMPORTANT NOTE:

Proper installation is the responsibility of the installer.  Improper installation will void warranty and may

result in poor performance and engine or vehicle damage.