F&U PA-120 Instructions For Use Manual - page 5
9. ALARM
When the water tank is full,"E4" will be displayed on the display panel. To resume
operation, please remove the rubber cap of the drain hose to drain out the water firstly.
After finishing draining the water out, please restart the unit and then the unit can
operate normally.
REMOTE CONTROL FUNCTION
1. POWER
2. FUNC
3. TIMER
4. AUTO
5. HI
6. MID
7. LOW
8. SLEEP
9. TEMP.
Stop/Start switch
Function “MODE” selector
Hourly programming
Automatic fan speed
High fan speed
Medium fan speed
Low fan speed
Night operation selector
Temperature selector
NOTICE
This unit can evaporate the condensation and flow out through
the exhaust hose automatically.
1. When the unit is in the cooling or heating
function, it does not need to install the
drain hose. Please make sure that the rubber cap is locked on drain hose, when the
unit is running.
2. When operating heating function, in order to improve the heating effect or prevent
low temperature(lower than 17
℃), water full phenomenon will happen . And then we
suggest to pull out the
“
②”rubber cap.
3. When operating dehumidifying function
。
“
①” rubber cap on drain hose should be pulled out and install a proper drain hose.
● Please remove the air exhaust hose, connect a drain hose to the drain hole and lead
the water to the outside in order to let the dehumidifying capacity more strong.
MAINTENANCE
PLEASE DISCONNECT THE POWER CORD BEFORE
CLEANING.