Fastec TS3 Quick Start Manual

Page of 3

Download

Bookmark us

TS3 / TS4 / TS5 Quick Start Guide

1. USB OTG (Micro connector)

2. SDHC (SD-card slot)

3. GigE Port (RJ45 connector)

4. LVTTL I/O, Sync, Trigger, etc. (Lemo connector)

5. HDMI Port (Type A connector)

6. DC Power In (Lemo connector)

1. Power LED

2. Network activity LED

3. Storage activity LED

4. Camera status LED

5. Sync activity LED

6. Battery status LED

7. Power ON/OFF button

8. Arm button

9. Display button

10. Menu button

11. D-Pad

Unpack the camera and assemble the following equipment:

1. TS3 / TS4 /TS5 camera

2. Camera power adapter with AC power cord, or charged battery inserted in the camera. (The battery is fully

charged when shipped from the factory.)

3. Lens

1. Trigger button

2. Power button

3. USB port

4. Top mount 1/4 -20

5. Camera strap attachment

6. 1/4-20 Tripod mount

7. Hand strap attachment point

8. Battery door

Equipment

Camera Views

1 2 3 Next › »

Page 1
Ts3 / ts4 / ts5 quick start guide 1. Usb otg (micro connector) 2. Sdhc (sd-card slot) 3. Gige port (rj45 connector) 4. Lvttl i/o, sync, trigger, etc. (lemo connector) 5. Hdmi port (type a connector) 6. Dc power in (lemo connector) 1. Power led 2. Network activity led 3. Storage activity led 4. Camer...
Page 2
1. On/off button powers the camera on and off. If the battery is installed and the power adapter is attached, the battery charging dialog will appear (see the section on power, below). 2. Disp button toggles the display through several modes: display on, display on with histogram, and display off. W...
Page 3
1. Select the save icon from the playback controls. This will bring up a dialog that allows selection of the following: • start and stop points of the clip (these points can also be changed using cut in/out buttons on the playback controls). • destination—where the movie clip is to be saved. Choices...