1. DL manuals
  2. Felker
  3. Saw
  4. FTS-15
  5. Operating Instructions And Parts List Manual

Felker FTS-15 Operating Instructions And Parts List Manual

Manual is about: Felker OPERATING INSTRUCTION Tile Saw FTS-150

Summary of FTS-15

  • Page 1

    Operating instructions and parts list instructions d’utilisation et liste de piÈces instrucciones de operaciÓn y lista de piezas fts-150 tile saw model: fts-150 115v/60/1 0af04106 copyright © december, 2003 electrolux construction products 17400 west 119th street olathe, kansas 66061 customer servic...

  • Page 2

    2 every machine is thoroughly tested before leaving the factory. Each machine is supplied with a copy of this manual. Operators of this equipment must read and be familiar with the safety warnings. Failure to obey warnings may result in injury or death. Follow instructions strictly to ensure long se...

  • Page 3: Warning

    3 antes de salir de nuestra fÁbrica, cada mÁquina es sometida a purebas detenidas. Cada mÁquina de corte es entregada con una cipia de este manual. Los operarios de estos equipos deben leer y familiarizarse con las instrucciones de seguridad. El no prestar atenciÓn a estas advertencias puede ocasion...

  • Page 4: Symbols Definitions

    4 symbols definitions symboles definición de simbolos • please read the instructions for use prior to operating the machine for the first time. • avant toute mise en service, lire attentivement la notice et se familiariser avec la machine. • antes de la puesta en marcha, lea detenidamente las instru...

  • Page 5

    5 • wear appropriate clothing • port obligatoire de la tenue appropriée • usar ropa adecuada • machinery hazard, keep hands and feet clear • danger! Rester à distance de la machine • máquina peligrosa - mantenga manos y pies alejados de la máquina • no non-working personnel in area • zone interdite ...

  • Page 6

    6 decal descriptions & location autocollants – descriptions et emplacements descriptiÓn de calcamonias y ubicaciones p/n 193015 location: blade guard – top sides p/n 193014 location: water tray – front p/n 046326 location: motor – front p/n 046327 location: motor – rear p/n 189247 location: control ...

  • Page 7: Notes:

    7 notes:.

  • Page 8: Safety First!

    8 safety first! Warnings do’s and do not’s warning: failure to comply with these warnings and operating instructions could result in death or serious bodily injury. Do do read this entire operator’s manual before operating this machine. Understand all warnings, instructions, and controls. Do keep al...

  • Page 9: Safety First!

    9 safety first! Warnings do’s and do nots warning: failure to comply with these warnings and operating instructions could result in death or serious bodily injury. Do not do not operate this machine unless you have read and understood this operator’s manual. Do not operate this machine without the b...

  • Page 10

    10 mandatory indication information instruction warning prohibition these signs will give advise for your safety before leaving our factory every machine is thoroughly tested. Follow our instructions strictly and your machine will give you long service in normal operating conditions. 1. Features use...

  • Page 11

    11 general assembly instructions • assemble saw stand (fig 1). Set on level surface and lock both wheels to resist movement while placing saw on stand. • fasten saw frame assembly onto assembled saw stand using t-knobs. (10, fig 1b) • install water tray assembly to frame. (fig 2) • install motor sup...

  • Page 12

    12 cutting head installation (fig 3) • remove cutting head assembly (1) and frame and pan assembly (2) from carton. • using the multi-wrench provided, install the motor support shaft (3) into the rear support post (4). Install and tighten the capscrew (5) with washer to retain the support shaft (3)....

  • Page 13

    13 water pump installation • remove the water pump from its packaging and check it to be sure it is not cracked or damaged in any way. • attach the end of the plastic tubing from the blade guard and to the water pump. • place the water pump in the rear of the water tray and be sure it is below the w...

  • Page 14

    14 extension cords • use only extension cords that are intended for outdoor use. These cords are identified by a marking “acceptable for use with outdoor appliances; store indoors while not in use.” use only extension cords having an electrical rating not less than the rating of the product. Do not ...

  • Page 15

    15 water tubing removal plastic tubing connects the water pump to the blade guard. The fittings used to connect this tubing seal and grip the outside diameter of the tubing. Special internal locking fingers attached to the flanged collet hold the tubing fast. To clean the water tubing requires the t...

  • Page 16

    16 7. Trouble shooting guide saw won’t start, saw is too slow to start, blade doesn’t turn and motor makes “humming” noise • make sure plug is in live electrical circuit. • voltage from source may be too low. • start capacitor defective. Replace. Saw shuts off abruptly • power is interrupted, check ...

  • Page 17

    17 10. Accessory use & installation 169872 adj. Protractor fig 55, diagram 1 169871 dual 45 ° miter fig 56, diagram 1 169870 45 ° bullnose guide fig 57, diagram 1 cart extension: p/n 185282 the extension adds supportive length to the cutting table. Use when cutting tile that extends beyond the front...

  • Page 18: La Sécurité Avant Tout !

    18 la sÉcuritÉ avant tout ! Mises en garde faire et ne pas faire attention: le mon respect de ces mises en garde et instructions d’utilisation peut entraÎner la mort ou des blessures corporelles graves faire faire lire ce manuel d’utilisation entièrement avant d’utiliser cette machine. Comprendre to...

  • Page 19: La Sécurité Avant Tout !

    19 la sÉcuritÉ avant tout ! Mises en garde faire et ne pas faire attention : le mon respect de ces mises en garde et instructions d’utilisation peut entraÎner la mort ou des blessures corporelles graves ne pas faire ne pas utiliser cette machine avant d’avoir lu et compris ce manuel de fonctionnemen...

  • Page 20: ¡seguridad Ante Todos!

    20 ¡seguridad ante todos! Advertencias hacer y no hacer advertencia: el no respetar estas advertencias e instrucciones de operacion puede provocar graves lesiones o la muerte. Hacer si lea todo el manual antes de manejar esta máquina. Entienda todas las advertencias, instrucciones y controles. Si ma...

  • Page 21: ¡seguridad Ante Todos!

    21 ¡seguridad ante todos! Advertencias hacer y no hacer advertencia: el no respetar estas advertencias e instrucciones de operacion puede provocar graves lesiones o la muerte. No hacer no haga funcionar esta máquina sin antes haber leído y entendido este manual. No maneje esta máquina sin tener la p...

  • Page 22

    22 diagram 1.

  • Page 23

    23 diagram 1 – fts-150 parts list diag. Loc. Part no. Qty req description diag. Loc. Part no. Qty req description 1 185004 1 stand assy 32 185080 1 v-belt (a-813) (incls. 1, 2, & 3 ) 33 185294 1 power switch housing assy 2 185017 2 wheel w/ brake & fasteners (incls. 33 – 35 & 57-58) 3 185018 2 knobs...

  • Page 24

    24 wiring diagram: notes:.

  • Page 25

    Felker’s new equipment warranty except as noted below. Felker warrants that its new equipment will be free from manufacturing defects for a period of two (2) years from date of purchase by the original consumer purchaser. The above warranty is subject to the following new equipment exceptions: 1. Th...

  • Page 26

    Felker corporate office 17400 west 119th street olathe, kansas 66061 phone: 913-928-1000 customer service tel: 800-365-4003 customer service fax: 800-825-0028 corporate office fax: 913-438-7951 customer service int'l: 913-928-1258 western division center 2012 abalone avenue torrance, ca 90501 310-38...