G4S S880 Installation And User Instructions - page 2
3
Reader Links
Present the card face-on to the reader until you hear a "bleep". Cards can be presented in rapid
succession; there is no
need, for example, to wait for "UNLOCKED" to disappear before presenting
another.
If the reader has been enabled for user-code mode at the controller, you can gain access by pressing the
O
key, entering your card number, then pressing the
P
key.
A Setup menu can be displayed by pressing the
O
and
P
keys simultaneously while power is applied. You
can use the menu to change the contrast and language used for the LCD (default English). Use the four
function keys to navigate around the menu.
Please refer to M2150 Intrusion Guide, 9600-0540 for IDS Arm / Disarm procedure.
9600-0568.
Installation and User Instructions for S880 Readers,
Issue 1.0 18th August 20111. G4S Technology, 2011.
FCC Notice: This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
Any unauthorized modification to this device may void the authority of
the user to operate it. All trademarks acknowledged.
©
LED Status Indicator
GREEN –The lock is released and you may open the door.
RED –You do not have access rights to gain entry, or the reader did not read your card properly (in
this case, present it again).
YELLOW –Enter your PIN. If you make a mistake, the message INVALID PIN is momentarily
displayed, followed by ENTER PIN, to prompt you to try again.
Specifications
Input voltage: 9-14Vdc.
Input current: 200mA @ nom. 12Vdc.
Operating temperature: 14 to 131°F (-10 to 55°C)
Operating humidity: 15 to 90%, non-condensing.
Maximum read range: 4" (100mm).
Approvals: EN50133, EN300330, EN301489
4
Using the Reader
Set LK2 (COMMS) across the center and WE pin for Wiegand communications, or across the center and
CL pin for 20mA current loop communications. Set LK3 (USER Keypad audio feedback) to 1 for sound
on, or 0 for sound off.