Galactron MK 2280 Owner's Manual

Summary of MK 2280

  • Page 1

    1 owner’s manual mk 2280

  • Page 2

    2 thank you and congratulation. By choosing galactron you have not only purchased a sophisticated and refined piece of hi-fi sound reproduction equipment but have also acquired 40 years of experience, research and interrupted love for music. The most important content of your new galactron is not it...

  • Page 3

    3 before starting your galactron amplifier is ready out of the box to be plugged into the household wall outlet and to other components of your hi-fi system without the need for internal setting. Do not open the amplifier case for any reason: any repairs or adjustment to be made inside the unit must...

  • Page 4

    4 placement the dissipation of the heat produced by the power mosfet is a slot way, placed above. The particular configuration as it takes advantage of the upward convection of hot air, drawing it down over the device and funnelling it to the upper slots. With this solution it is not necessary to pr...

  • Page 5

    5 on the front panel there are: power red led. It lights red when put in the "off" the power switch, it indicates that the amplifier is connected to the network, but in stand-by mode. Warm-up in the moment of switching on the amplifier, for about 30 seconds, the red led will flash with the selected ...

  • Page 6

    6 how to operate the amplifier connecting speakers the power outputs are made with screw terminals gold, able to accept both bare wire up to 6 mm2, both terminations fork, both terminations standard banana with 4 mm diameter. The use of simple stripped cable is, however, not recommended due to the s...

  • Page 7

    7 when you press one of the volume control buttons on the remote control, the front panel will illuminate on and the arrow that indicates whether the level is climbing or descending. Arriving at the maximum attenuation or maximum exaltation written and arrows do not light up anymore, indicating that...

  • Page 8

    8 the speakers are hooked-up incorrectly. Check that the speakers are correctly connected to the output terminals. If the connection are correct, the power cable are interrupted. Check the continuity of the cables. If they are not interrupted, a fuse might as blown into the amplifier’s pc board. Hav...

  • Page 9: Instructions For Recycling

    9 instructions for recycling the symbol on the side, shown on the packing of the product means that the product, if it is no longer used, cannot be treated as unsorted municipal waste, but must be returned to a collection point for the recycling of electrical and electronic equipment, in accordance ...

  • Page 10

    10 conventions and meaning of the symbols this document contains instructions on generic safety, installation and use for filter power mk-600. It 'important that you read this document before groped to use this amplifier. Pay particular attention to the safety instructions. Appears on the unit to in...