Game Winner FSGWBG1000 Assembly Manual

Manual is about: hunter's grill

Summary of FSGWBG1000

  • Page 1

    Hunter’s grill model #fsgwbg1000 customer service: (888) 837-1380, 8:00am to 5:00pm, pacific standard time, monday thru friday (made in china) please keep this instruction manual for future reference assembly instructions brand sc2000314-gw-00 – eng p.1 20131026-v1.

  • Page 2: Contents

    Warnings -------------------------------------------------------------------------- tools required ------------------------------------------------------------------- component list ----------------------------------------------------------------- hardware -------------------------------------------...

  • Page 3: Warnings

    Warnings please read safety and precaution statements, grill maintenance, leak testing, regulator/ cylinder connection and lighting instructions before using grill the first time. Safety symbols the symbols and boxes shown below explain what each heading means. Read and follow all of the messages fo...

  • Page 4: Warnings

    Warnings danger if you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. Open lid. 4. If odor continues, keep away from the appliance and immediately call your gas supplier or your fire department. Failure to follow these instructions could result in fire or explosion whi...

  • Page 5: Warnings

    • the appliance shall not be used on or under any apartment or condominium balcony or deck. • the appliance shall be used outdoors only, and shall not be used in a building, garage or any other enclosed area. • this appliance is not intended to be installed or used in or on a recreational vehicle or...

  • Page 6: Before Installing:

    Use of lp gas cylinder and installation before installing: lp gas cylinder • the installation must conform with local codes or, in the absence of local codes,with the national fuel gas code, ansi z223.1/nfpa 54, storage and handling of liquefied petroleum gases, ansi/nfpa 58; or natural gas and prop...

  • Page 7: Warnings

    Warnings caution (a) do not store a spare lp-gas cylinder under or near this appliance; (b) never fill the cylinder beyond 80 percent full; and never refill 16.4 oz bottles. (c) if the instructions in “(a)” and “(b)” are not followed exactly, a fire causing death or serious injury may occur. Leak te...

  • Page 8: To Test

    To test 1. Make sure the control knobs are in the “off” position, and turn on the gas supply. 2. Check all connections at the gas cylinder, lp gas regulator and supply valve up to and including all connections to the pipe that go to the burners (the diagram shows the point where the soap water mixtu...

  • Page 9: Warnings

    Warnings warning natural hazards -insects and spiders a clogged tube can lead to a fire beneath the appliance. During shipment or storage, it is possible that small insects and spiders could find their way into the venturi tubes and make nests or webs. This could block the flow of gas through the ve...

  • Page 10: Tools Required

    1 philips & flathead screwdrivers 2 pliers 3 hex nut wrench tools required sc2000304-og-00 – eng p.10 20131026-v1.

  • Page 11: Parts List

    Parts list 1 lid handle 1pc 2 lid handle bracket 2pcs 3 grill body assembly 3a: grill body with hose regulator assembly – 1 pc 3b: grill lid – 1 pc 3c: legs – 1 set 3d: control knob – 2 pcs 3e: lighting rod – 1 pc 3f: lid lock – 1 pc 3g: heat shield – 1 pc 3h: hinge (top) – 2 pcs 3i: hinge (bottom) ...

  • Page 12: Parts List

    Parts list 6 flame tamer 2pcs 7 side table assembly 7a: side table – 1 pc 7b: lock assembly – 1 pc 8 wheel 2pcs 9 wheel cover 2pcs 10 oil drip tray 1pc 11 plastic leg base 2pcs sc2000304-og-00 – eng p.12 20131026-v1 7a 7b.

  • Page 13: Hardware

    Hardware a wheel bolt 2 pcs b m10 washer 2 pcs c m6 * 15mm bolt 4 pcs d m6 washer 4 pcs e m6 * 55mm bolt 2 pcs f cotter pin 4 pcs sc2000304-og-00 – eng p.13 20131026-v1.

  • Page 14: Assembly Instructions

    Assembly instructions sc2000304-og-00 – eng p.14 20131026-v1.

  • Page 15: Assembly Instructions

    Assembly instructions step 1: take out the grill body (3) from the packing box and keep the grill body in folded position. Loosen the screws on legs as following. Insert these screws through the center hole of the plastic leg base(11) and tighten them firmly. Step 2: insert the wheel bolt (#a) throu...

  • Page 16: Assembly Instructions

    Assembly instructions unfold the grill as per following figure. Sc2000304-og-00 – eng p.16 20131026-v1 step 3a: step 3b:.

  • Page 17: Assembly Instructions

    Assembly instructions step 4: attach side table (7) to grill body by using 4 pcs of m6x15mm bolt (#c) and m6 washer (#d). #c –m6x15mm bolt x 4 pcs #d – m6 washer x 4 pcs sc2000304-og-00 – eng p.17 20131026-v1 7 #c & #d #c & #d.

  • Page 18: Assembly Instructions

    Assembly instructions step 5: insert m6x55mm bolts (#e) through the lid handle brackets (2) and lid handle (1). Tighten the the handle firmly to the lid. Step 6: place the flame tamer (6) over the burners and use 4 pcs of cotter pins (#f) to maintain the tamers in position. #e - m6x55mm bolt x 2 pcs...

  • Page 19: Assembly Instructions

    Assembly instructions step 7: place the cooking grates (4 and 5). Step 8: insert the oil drip tray (10) under the grill body. Assembly is completed!!! Before cooking for the first time operate grill 15 minutes with grill lid closed and gas control on high. This will heat-clean internal components an...

  • Page 20: Operating Instructions

    Operating instructions unfold grill note: unlock the latch before unfolding the legs sc2000304-og-00 – eng p.20 20131026-v1 step 1: step 2:.

  • Page 21: Operating Instructions

    Operating instructions fold grill warning propane gas cylinder must be detached from regulator before folding the grill do not fold the grill or move the grill immediately after cooking. Wait for the grill to cool down completely! Note: side table should be completely folded before moving the gril...

  • Page 22: Operating Instructions

    Operating instructions fold / unfold side table lighting instructions 1. Read all instructions before lighting 2. Open lid during lighting 3. Make sure the propane gas cylinder is tightly threaded into the regulator (hand tighten only). 4. Push and turn main burner knob slowly to “hi”. 5. Press the ...

  • Page 23: Operating Instructions

    Operating instructions manually lighting your grill by match 1. Important! Open lid. Attempting to light burner with lid closed may cause an explosion. Do not expose any part of your body or clothing directly above cooking area when lighting. 2. Using the lighting rod with a match, ignite the match ...

  • Page 24: Operating Instructions

    Operating instructions turning grill off • after cooking, turn the grill off by rotating the control knob to off. Control knob should pop up in the off position. If control knob does not pop up, disconnect cylinder to turn grill off and replace the regulator. • this appliance will be hot during and ...

  • Page 25: Grill Maintenance

    Grill maintenance grill maintenance • clean and inspect pressure regulator and hose assembly prior to use. • allow grill to cool before cleaning. Frequency of cleaning is determined by how often grill is used. • do not use self-cleaning oven to clean any grill part. Extreme heat would remove any chr...

  • Page 26: Grill Maintenance

    Grill maintenance to reinstall the main burners: 1. Insert the burner over the main burner gas valve. 2. Make sure the orifice spud (a) is inside the burner venturi (b) 3. Align the burner screw hole with the firebox hole, insert screw and tighten. Burner venturi (b) control valve orifice spud (a) s...

  • Page 27: Warranty Information

    Warranty information 1. Manufacturer warrants this product to be free from defects in workmanship and materials for a period of 90 days from the date of purchase, provided claims are submitted, in writing, with proof of purchase. 2. If any part of this item fails because of a manufacturing defect wi...

  • Page 28: Warranty Information

    If customer service is necessary: the original purchaser is responsible for shipping and handling charges of the returned item(s) and replacement parts, if any. All parts to be replaced will need to be shipped before replacement items will be sent. Follow the customer service representative’s instru...