- DL manuals
- H3C
- Fan
- LSW1BFAN
- Installation Manual
H3C LSW1BFAN Installation Manual
Summary of LSW1BFAN
Page 1
H3c lsw1fan and lsw1bfan installation manual hangzhou h3c technologies co., ltd. Manual version: 5w101-20090605.
Page 2
Copyright © 2008-2009, hangzhou h3c technologies co., ltd. And its licensors h3c technologies co., ltd., a subsidiary of 3com corporation. All rights reserved no part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of hangzhou h3c technologie...
Page 3
About this manual organization h3c lsw1fan and lsw1bfan installation manual is organized as follows: chapter contents 1 fan tray overview describes thefan tray and hardware specifications. 2 removing/installing a fan tray describes removal and installation of the fan tray. Appendix appendix a: obtai...
Page 4
Select documentation for type of file and select product category. Technical support please see the appendix obtaining support for your product. Documentation feedback you can e-mail your comments about product documentation to info@h3c.Com. We appreciate your comments. Environmental protection this...
Page 5: Table of Contents
I table of contents 1 fan tray overview·····································································································································1-1 lsw1fan overview and specifications·························································································...
Page 6: Fan Tray Overview
1-1 1 fan tray overview the matrix between the two models of fan trays introduced in this manual and the ethernet switches to which they are applicable is as shown in table 1-1 . Table 1-1 fan tray and device matrix fan tray switch model s5800-32f s5810-50s lsw1bfan s5820x-28s s5800-60c-pwr lsw1fan ...
Page 7
1-2 lsw1fan specifications table 1-2 lsw1fan specifications specification description fan number z two 70 × 70 × 25.4 mm (2.76 × 2.76 × 1 in.) fans z four 40 × 40 × 28 mm (1.57 × 1.57 × 1.1 in.) fans fan speed z 70 × 70 × 25.4 mm (2.76 × 2.76 × 1 in.) fans: 4700 r.P.M z 40 × 40 × 28 mm (1.57 × 1.57 ...
Page 8
1-3 figure 1-2 lsw1bfan view (1): captive screw (2): air vent (3): fan tray handle (4): captive screw lsw1bfan specifications table 1-3 lsw1bfan specifications specification description fan number 1 fan speed 5000 r.P.M max airflow 41.65 cfm input voltage 12 v power consumption 24 w acoustics normal...
Page 9
1-4 table 1-4 fan tray fail leds description led mark state system status led sys steady red seven-segment led unit the led displays f for fan failure. Only when the system status led and the seven-segment led are displayed as steady red and f respectively does it indicate that a fan tray fails..
Page 10
2-1 2 removing/installing a fan tray z the lsw1fan and lsw1bfan fan trays are hot swappable, and therefore can be replaced with the device running. Z the two models of fan trays and the devices are installed when shipped. This chapter mainly introduces how to replace a fan tray when it fails. The fa...
Page 11
2-2 figure 2-1 remove an lsw1fan (1) figure 2-2 remove an lsw1bfan (1) 3) holding the handle of the fan tray with one hand, pull part of the fan tray out. Then supporting the bottom of the fan tray with the other hand, pull it straight out of the fan tray slot along the guide rails, as shown in figu...
Page 12
2-3 figure 2-3 remove an lsw1fan (2) figure 2-4 remove an lsw1bfan (2) after removing a fan tray, place it in an antistatic bag. Installing a fan tray 1) put on an esd-preventive wrist strap, make sure that the wrist strap has a good skin contact and is well grounded. 2) take out the fan tray from t...
Page 13
2-4 figure 2-6 install an lsw1bfan (1) 4) fasten the screws with a phillips screwdriver until the fan tray is well seated in the chassis, as shown in figure 2-7 and figure 2-8 . Figure 2-7 install an lsw1fan (2) figure 2-8 install an lsw1bfan (2) z to avoid damaging the connectors on a fan tray and ...
Page 14
2-5 maintaining a fan tray to ensure normal operation and long service life of your fan trays, note the following when using fan trays: z put on an esd-preventive wrist strap and ensure a good skin contact. Z adequate clearance is reserved at the air inlet/exhaust vents for ventilation. Z the rack o...
Page 15
A-1 appendix a obtaining support for your product register your product warranty and other service benefits start from the date of purchase, so it is important to register your product quickly to ensure you get full use of the warranty and other service benefits available to you. Warranty and other ...
Page 16
A-2 warranty and other service benefits start from the date of purchase, so it is important to register your product quickly to ensure you get full use of the warranty and other service benefits available to you. When you contact 3com for assistance, please have the following information ready: z pr...