Home of ultra ax314 / ax315 / ax316 smart technology electric shower important: important: this booklet should be left with the user after installation and demonstration. We offer a technical advisory service on the telephone to contractor with problems in the field. Ring 0844 372 7766 installation ...
2 contents if you experience any difficulty with the installation or operation of your new shower, then please refer to the “what to do if things go wrong” section in this manual before contacting us. Introduction thank you for purchasing a quality home of ultra shower manufactured in england. To en...
3 warning: all wiring and installation must be supervised by a suitably qualified person. Warning: do not install this shower where it may be subjected to freezing conditions we recommend that the installation is done in the following sequence. A. Fixing the shower to the wall b. Plumbing c. Electri...
4 7. If you have not yet done so, remove the front cover assembly by undoing the retaining screws at the top and bottom of the unit and lifting the cover off. Your shower is provided with 2 fixing positions in the backplate (see diagram 7 on page 9). The top-fixing hole is a “key-hole” slot (another...
5 c) electrical warning: this shower must be earthed. The electrical installation must be in accordance with the current bs.7671 (iee wiring regulations) and “part p” of the building regulations and/or local regulations 1. The shower unit is designed for a single phase ac electrical supply. Please c...
6 how to maintain your ax314 / ax315 / ax316 shower 5. Re-fit the front cover (see diagram 5), and secure by replacing the top and bottom fastening screws. A. Ensure knob “a” is aligned to the “high” position. B. Ensure knob “c” is aligned to “12 o’clock. C. In the main body of the shower, turn the ...
7 if water is too cold turn knob “c” anti-clockwise in the direction of the “red arrows” until the next number is displayed in window “d” and continue turning anti-clockwise until you get the water temperature of your liking. Wait 20 seconds after each adjustment for the water temperature to stabili...
8 self help if the shower is not working satisfactorily, make the following checks before calling out the installer. Any one of these adjustments could restore the performance. The shower cycles from hot to cold the shower temperature is set too hot causing the thermal cut-out (safety device) to ope...
9 what to do if things go wrong (2) home of ultra after sales service professional service if the previous “self help” checks fail to restore the performance, you should seek professional help. The person who installed the shower is probably the best one to investigate and correct it and is certainl...
10 1. Water is heated instantaneously as it flows over the heating elements in the copper cylinder (diagram 8). 2. The heaters are only switched on when sufficient water is flowing. This is done automatically with a switch which works on water pressure and is indicated by 2 or 3 lights illuminating ...
11 : full details of terms and conditions are available on request from:- manufactured in england for:- ultra finishing limited widow hill road, heasandford industrial estate, burnley, lancs, bb10 2be tel: 01282 436934 / fax: 01282 428915 technical advice line: 0844 372 7766 website: www.Ultra-group...
12 how to use your ax314 / ax315 / ax316 shower (summary) important warnings! Do not switch the appliance on if you suspect it of being frozen. Wait until you are sure it has thawed out. Do not operate the appliance if water discharges from the pressure relief valve. Maintenance is required before t...
